so got me a new xbox and wanted to flash it and i got all my key dummys for the lite on
i have a lite on 83850C v1 and running it on 64 bit win 7 on via card and after a erase
the drive is no longer detectable on jungle flasher . . . what do i do?
i ahve tried using dos using the command l-o-eras.exe ec00 but it gives me status of FFFF
what happened ?
Any ideas of what i should do?
Thanks.!
Originally posted by helpplz06: so got me a new xbox and wanted to flash it and i got all my key dummys for the lite on
i have a lite on 83850C v1 and running it on 64 bit win 7 on via card and after a erase
the drive is no longer detectable on jungle flasher . . . what do i do?
i ahve tried using dos using the command l-o-eras.exe ec00 but it gives me status of FFFF
what happened ?
Any ideas of what i should do?
Thanks.!
Did you follow the jungleflasher tutorial using the half-tray method?
"All drives should be updated to Lite Touch + (LT+) firmware if playing on XBOX live. Samsung drives and pre-78/79 Hitachi drives do not utilize AP 2.5. All other drives are considered to be detectable by Microsoft (YMMV). Make sure all rips are ABGX verified, contain SSv2, and patched AP2.5 (where needed). XGD3 must currently be burned on new drive with PC Burner Max firmware for 100% rip. All modded consoles can be potentially unsafe for use on XBOX live."
Originally posted by helpplz06: yea i did and after erase it just like froze and its not detectable anymore . . but i did get my key and important stuff.
or is my drive still usable . . brand new xbox too
It's really hard to brick a lite-on, so I would keep trying. If you are using your console to power the drive during flashing (make sure you plug the power connector in the right way!), the half-tray method can be a bit tricky. When you have it set, try re-sending the erase command until you get good flash properties. Also make sure the video cable is plugged in to the back of the console.
"All drives should be updated to Lite Touch + (LT+) firmware if playing on XBOX live. Samsung drives and pre-78/79 Hitachi drives do not utilize AP 2.5. All other drives are considered to be detectable by Microsoft (YMMV). Make sure all rips are ABGX verified, contain SSv2, and patched AP2.5 (where needed). XGD3 must currently be burned on new drive with PC Burner Max firmware for 100% rip. All modded consoles can be potentially unsafe for use on XBOX live."
Originally posted by helpplz06: yea i did and after erase it just like froze and its not detectable anymore . . but i did get my key and important stuff.
or is my drive still usable . . brand new xbox too
erase your viaraid.sys in the system32 drivers folder,load up JF remeber what port you was using,load your dummy key then firmware,then go back to LO erase and follow the steps you should get your status back and then write
