Thanks I am trying to flash my firmware, have some problems right now, can you help:
1) my OS is 64bit win7 , I have Lite on 74850c drive.
2) I removed the viamraid.sys in win32 folder, disable the signature thing.(I am using win7 , under my Device management , and storage controller, there is only "ADBOUUYB IDE Controller". NO "VIA controller" so I don;t know where to uninstall the VIA driver. I only remove the viamraid.)
3) I then manually put my lite on drive to half tray position followed the guide. (no connectivity kit)
4) re-connect to SATA, and xbox360 power cable, start the pc.
5)Problem is when I try to run Jungleflasher, it takes about 5 minutes to appear, then I cycle the I/0, it can't detect my drive. however, my pc shows the NEW cd drive.
6)my sata chip is AMD 790X, I don't know if that is the problem.?
the portio64.sys I installed it and it shows in the jungleflasher log:
JungleFlasher 0.1.70 Beta
Session Started Fri Feb 19 18:04:25 2010
This is a Wow 64 process running on 4 x 64 bit CPUs
portio64.sys Driver Installed
portio64.sys Driver Started, thanks Schtrom !
Found 6 I/O Ports.
Found 1 Com Ports.
Found 7 windows drives A: C: D: G: I: J: K:
Jungleflasher now CAN ONLY show up once I disconnect the SATA cable from it.
You are removing the VIA driver but you are using onboard SATA?
If you are infact using onboard SATA, go over to the DVDkey32 tab and make sure "Include non-IDE ports" is ticked. Also try your LiteOn on a different SATA port.
Also, don't start your LiteOn drive up with the tray half way closed. Leave it fully closed until you get it detected.
