Hi Guys I have a benq with 1.60 and i want to put OFW on it , I have the files downloaded Original_Philips-BenQ_VAD6038_64930C.rar , I have scoured the site and i can not find the answer so help would be appreciated, My first question is when i press benq unlock it sends the keys but i get Vendor intro failed and if i try and read it says invalid status 0x51 , I am probally doing somthing stupid , I do not have the drive half open as Ive read here you do not need to.
My second question is in the file Original_Philips-BenQ_VAD6038_64930C.rar i Have three bin files org-64930c_b030.bin ,
org-64930c_e030_1.bin , org-64930c_e030_2.bin , Which one do i use when i have gained my dvd key.
For this method, we still need to power on the drive with the ?half open tray?.
If using a 360 to power the drive
This method can be tricky to accomplish.
You need to power on the drive with Eject status closed but Tray Half Open ? To do this using
an Xbox 360 as Power source, eject the DVD drive, then, press eject to ?close? the tray. Now this
is the important part ? you MUST remove the DVD power plug from the DVD Drive BEFORE it
closes fully.
Wait for a few seconds and replace the power plug into the DVD drive taking extreme caution
to plug the plug the right way around ? once done, the drive is now powered, console thinks its
closed but it is in fact half open.
Load JungleFlasher, and select MTKFlash 32 tab.
The drive should be in Vendor Mode (0x70) now and return good flash chip properties, you can
check in the Running Log or Flash Chip Properties, The drive should also show as ?Drive In
Vendor Mode!? in the Drive Properties.
