just wanted to start by saying I've been a long time visitor to this forum, but this is my first post.
my problem is I have a Zephyr 360 with the dash below 7371, so to the best of my knowledge it is jtagable. the problem is when I use jtag tool to write xell I get the E79 error, to make matters worse for me is I dont have my orig nand (long story) and when i read the nand I get 4 bad block when I use jtag tool. I used the pin headers that came with the nand-x kit and at first I used the QSB for the jtag but now I soldered the wires under the motherboard, I think its called the AUD_Clamp. So can anyone help me with what else to try or just tell me I'm out of luck so I can stop getting frustrated. Thanks in advance.
Come talk with us on efnet at #elitemods !!! or just click ME
ALSO, DO NOT SEND ME MESSAGES ON LIVE REGARDING MODDING CONSOLES, OR HOW I PLAYED A CERTAIN GAME EARLY. I WILL NOT RESPOND. I WILL INSTEAD DELETE YOUR MESSAGE, AND BLOCK ALL COMMUNICATION FROM YOU. JUST SEND ME A PM ON HERE.
sorry if this is a dumb question but how do I do that with jtag tool 4.21? I dont see where you can choose which version of Xellous to write. should I get an older version of Jtag tool?
Come talk with us on efnet at #elitemods !!! or just click ME
ALSO, DO NOT SEND ME MESSAGES ON LIVE REGARDING MODDING CONSOLES, OR HOW I PLAYED A CERTAIN GAME EARLY. I WILL NOT RESPOND. I WILL INSTEAD DELETE YOUR MESSAGE, AND BLOCK ALL COMMUNICATION FROM YOU. JUST SEND ME A PM ON HERE.
Come talk with us on efnet at #elitemods !!! or just click ME
ALSO, DO NOT SEND ME MESSAGES ON LIVE REGARDING MODDING CONSOLES, OR HOW I PLAYED A CERTAIN GAME EARLY. I WILL NOT RESPOND. I WILL INSTEAD DELETE YOUR MESSAGE, AND BLOCK ALL COMMUNICATION FROM YOU. JUST SEND ME A PM ON HERE.
