Got my liteon to only get detected with ck3 lite and probe II. When i try to get it into vendor mode using intro/device id, I get the status 0x52. Here are my cuts.
http://i.imgur.com/Z90v7.jpg http://i.imgur.com/zHI36.jpg Im thinking my cuts arent deep enough but I'd want to be sure. Does anyone know whats the problem? Also, I tried all three resistor values on the probe II from 18, 20, and 22.
Originally posted by nintendoj: Got my liteon to only get detected with ck3 lite and probe II. When i try to get it into vendor mode using intro/device id, I get the status 0x52. Here are my cuts.
http://i.imgur.com/Z90v7.jpg http://i.imgur.com/zHI36.jpg Im thinking my cuts arent deep enough but I'd want to be sure. Does anyone know whats the problem? Also, I tried all three resistor values on the probe II from 18, 20, and 22.
They look fine to me, the R101 cut looks botched but thats just me. If you have a volt meter around put it on an Ohm setting(any ohm setting is fine) and put one lead on one side of the cut and one on the other, if the needle jumps up, the trace isn't cut enough, if it doesn't move, the cuts are good.
I've flashed it and got the key and firmware. My only problem is when i plugged everything in i get the red rings and my dvd drive doesnt eject. I think that i didnt put enough glue on the trace cuts. Is it okay if I go back and put more glue or is it too late? Is the glue the problem or could it be something else.
Walmart - around $5 will get you a basic multimeter. Make sure you have repaired the traces effectively. If not, putting more conductive paint will not hurt anything. Just make sure it stays off of other traces. Also, depending on how you did the cuts, cutting R101 from the trace(old method) or cutting on either side of R101, you might have damaged R101 and need to repair that.
