still rrod after heat gun fix

Advertise at AfterDawn.com

Link to us!

Private messages

Compose a private message

List of all updated threads

Threads without replies

Search messages

Monday 13.1.2025 / 03:44

Search AfterDawn Forums:

afterdawn.com > forums > consoles > xbox 360 - modding & hacking > still rrod after heat gun fix

Browse by topic

Forums

Start a new thread

still rrod after heat gun fix

Jump to:

Posted

Message

glh290

Newbie

9. June 2011 @ 21:13

Link to this message

i did the heat gun exactly as done in the video provided to me in my last post
by exactly i mean i got the same gun and did everything as the person in the video did exact timing everything
and i get the error 0103 again after the heat gun fix if there is any better instructions/suggestions i would be grateful

[ + quote]

This message has been edited since posting. Last time this message was edited on 9. June 2011 @ 22:12

glh290

Newbie

9. June 2011 @ 22:05

Link to this message

i should also say i found my ram chip pads and used them when i started the xbox and also waited 45 mins to let it cool

[ + quote]

MrGreaser

Senior Member

9. June 2011 @ 22:50

Link to this message

I would try again...this time, try flushing the motherboard with acetone (mainly under the chips) and use a toothbrush to VERY gently brush away any dust/debris from the surface of the board while flushing. Your error code suggests to me that you should concentrate your heat on the ANA/HANA chip and the GPU.

Using Kester No-Clean liquid flux (or similar no-clean flux) under the three main chips is always a good idea as long as you don't use too much and don't heat too long. The flux removes oxide buildup and basically rejuvenates brittle solder.

I use these methods to fix 0102/0103, E74, etc and have had a great success rate bringing back hundreds of consoles. I Hope it helps you to save yours.

[ + quote]

"All drives should be updated to Lite Touch + (LT+) firmware if playing on XBOX live. Samsung drives and pre-78/79 Hitachi drives do not utilize AP 2.5. All other drives are considered to be detectable by Microsoft (YMMV). Make sure all rips are ABGX verified, contain SSv2, and patched AP2.5 (where needed). XGD3 must currently be burned on new drive with PC Burner Max firmware for 100% rip. All modded consoles can be potentially unsafe for use on XBOX live."

glh290

Newbie

9. June 2011 @ 23:12

Link to this message