Using a e3 card reader i downgraded from 3.5 to 3.41 and went to leave factory mode but it failed, the ps3 green light just keeps flashing. if i tired to start without the usb the green light goes red
I backed up the usb card and re copied it to the usb stick and tried the last stage again
if i use a clean usb and just file 2 and no sys text then i get this message on the PS3
The system software cannot be run correctly. Press the PS buttonto try to restart the system
If the system cannot be restarted, you must reinstall the system software.
Connect storage media that contains update data of version 3.41 or later, and press the START and SELECT buttons at the same time.
For information on how to obtain update data refer to SCE Web site for you region
my sys.txt on the card is
manufacturing updating start
PackageName = /dev_usb000/PS3UPDAT.PUP
settle polling interval success
vflash is enabled...
creating system regions...
create storage region: (region id = 1)
create storage region: (region id = 2)
format partition: (region_id = 2, CELL_FS_UTILITY:HDD0, CELL_FS_UFS)
create storage region: (region id = 3)
format partition: (region_id = 3, CELL_FS_UTILITY:HDD1, CELL_FS_FAT)
creating system regions done.
boot from nor flash...
creating nor flash regions...
create storage region: (region id = 2)
create storage region: (region id = 3)
creating flash regions...
create storage region: (region id = 1)
create storage region: (region id = 2)
format partition: (region_id = 2, CELL_FS_IOS:BUILTIN_FLSH1, CELL_FS_FAT)
create storage region: (region id = 3)
format partition: (region_id = 3, CELL_FS_IOS:BUILTIN_FLSH2, CELL_FS_FAT)
create storage region: (region id = 4)
format partition: (region_id = 4, CELL_FS_IOS:BUILTIN_FLSH3, CELL_FS_FAT)
create storage region: (region id = 5)
create storage region: (region id = 6)
Initializing
taking a while...
start Updating Proccess
UpMng.UpdatePackage() failure
manufacturing updating FAILURE(0x8002f048)
Total Elapsed time = 20255 msec
