Im trying to soft mod by Nephews Wii he recently purchased, Serial #LU72223684-8 Version 4.1U. I used Larrylje tutorial which I used on mines previously and it worked fine. I tried sofmodding it to run back up Verbatim DVD-r but no luck. I kept getting read error 1101. After further research i found out that my nephews wii has the new GC2-D3-2 (v2) Chip which is unable to read DVD-r's. I attempted to install CFG USB Loader again using Larrylje's tutorial. However I followed the instructions twice to the letter, but am unable to get to this part;
Boot up CFG USB Loader. Press 1 on the Wiimote.
Press 1 again to get to global settings.
Go down to DOWNLOAD ALL MISSING COVERS and Press A
After covers are downloaded go down to UPDATE TITLES.TXT and Press A
Reboot USB Loader after TITLES.TXT is downloaded.
When i load CFG Loader it doesnt do anything when i press 1. As if it doesnt recognize it.
when i attempted to load a game via usb, the usb loader times out after 30 seconds.
Im trying to soft mod by Nephews Wii he recently purchased, Serial #LU72223684-8 Version 4.1U. I used Larrylje tutorial which I used on mines previously and it worked fine but it didnt work on my Nephews. I tried sofmodding it to run back up Verbatim DVD-r but no luck. I kept getting read error 1101. After further research i found out that my nephews wii has the new GC2-D3-2 (v2) Chip which is unable to read DVD-r's. I attempted to install CFG USB Loader using Larrylje's tutorial. However I am unable to get to this part;
Boot up CFG USB Loader. Press 1 on the Wiimote.
Press 1 again to get to global settings.
Go down to DOWNLOAD ALL MISSING COVERS and Press A
After covers are downloaded go down to UPDATE TITLES.TXT and Press A
Reboot USB Loader after TITLES.TXT is downloaded.
When i load CFG Loader it doesnt do anything when i press 1. As if it doesnt recognize it.
when i attempted to load a game via usb, the usb loader times out after 30 seconds.
Basically yes, it can't read it. Have you installed ciosfix.wad? USB loader stopped recognizing my device after I installed it so I uninstalled ciosfix.wad and reinstalled cios 249. It could be that the hard drive you are using is not compatible, check the
compatibility list.
If you haven't, make sure you got the latest cfg usb loader because it supports NTFS. You have installed Cios 222, right?
Also make sure you plugged the usb cable into the outer edge slot.
Hope that helps :D
