Originally posted by Romanay:

---

Hi yesterday I copyed the dvd Avatar using DVDFAB 7.0.4.0

It Say's completed successfully but when I play the copied disc in my dvd play after 2 hours and 14 minutes
the picture go's fuzzy for about 1 minute and then it go's back normal.

The writing speed I used was 1.0.

The disc I used were sony DVD+RW 4.7Gb 120 minutes

Can any body help.

---

Originally posted by paztelu:

---

Hi, in the original copy did you check if at the same spot the picture goes fuzzy?, was the DVD+RW new or was already used, check for any scratchs on the data surface of the disc, and maybe try to do a quality check with nero disc speed to see if there are any specific problems on any section of the dvd.

---

Originally posted by paztelu:

---

Hi, in the original copy did you check if at the same spot the picture goes fuzzy?, was the DVD+RW new or was already used, check for any scratches on the data surface of the disc, and maybe try to do a quality check with nero disc speed to see if there are any specific problems on any section of the dvd.

---

Originally posted by Romanay:

---

Originally posted by paztelu:

---

Hi, in the original copy did you check if at the same spot the picture goes fuzzy?, was the DVD+RW new or was already used, check for any scratches on the data surface of the disc, and maybe try to do a quality check with nero disc speed to see if there are any specific problems on any section of the dvd.

---

Yes I did check the original copy and it's fine

The DVD+RW has been used before but I have never had this problem before.
There are a couple of scratches on the disc could that be why?

---