Winfast TV2000 XP Expert audio problems

Advertise at AfterDawn.com

Link to us!

Private messages

Compose a private message

List of all updated threads

Threads without replies

Search messages

Wednesday 22.1.2025 / 06:02

Search AfterDawn Forums:

afterdawn.com > forums > digital video > video capturing from analog sources > winfast tv2000 xp expert audio problems

Browse by topic

Forums

Start a new thread

Winfast TV2000 XP Expert audio problems

Jump to:

Posted

Message

mr_nabo

Newbie

16. October 2004 @ 11:23

Link to this message

Hello all,

I've managed to configure my system to grab VCR video, radio and TV signals with sound in the resulting mpeg or wav. However, I fail to get sound to play 'live' while I watch TV/listen to radio suggesting a software configuration problem.

I've had to use my motherboard's onboard sound (SoundMAX digital audio) in place of my Echo Mia soundcard because the latter has no connections that connect directly to the TV2000 XP capture card. My settings in WinFast PVR are

AUDIO DEVICE: SoundMAX Digital Audio
AUDIO-OUT CONTROL LINE: Wave (with the option of SW Synth, Front, Rear, Center, Subwoofer, CD Player, Microphone, Aux, Line In, Phone, Mono Out, PC Beep and Wave again)
AUDIO RECORDING LINE: Aux
MASTER STREAM: Audio
RECORD VOLUME: 60

Do I need to change anything within Winfast PVR/Sound Control Panel or is it to do with my hardware?

Any help greatly appreciated

[ + quote]

One flew up her cuckoo nest.

xxnonamex

Suspended due to non-functional email address

16. October 2004 @ 12:46

Link to this message

I have the same tv/tuner card and when I record with it I get no sound. U followed the directions but to no avail. I have the audigy 2 soundblaster platinum. What am I doing wrong? Thanks

[ + quote]

mr_nabo

Newbie

16. October 2004 @ 14:17

Link to this message

If you've connected the internal audio cable (that comes out of your TV card) to your soundblaster sound card then you'll need to configure Winfast PVR. First check you've selected 'Soundblaster Audigy' as your AUDIO DEVICE and then make sure your AUDIO RECORDING LINE is selected on either AUX or an option specific to your soundcard - setting options change according to the soundcard type you have.

When installing my TV card I attached the internal audio cable to my mother board at the AUX socket (I believe it was next to the PCI slot where I installed the TV card) and then made sure I set up Winfast PVR correctly.

I read in another thread about setting your soundblaster sound card settings (in the control panel) to a 'what you hear is what you get' setting or something similar. Mess around with the settings first in PVR and then your control panel when you're confident you've selected the right option for PVR.

Hope that helps, write back if not.

[ + quote]

One flew up her cuckoo nest.

xxnonamex

Suspended due to non-functional email address

16. October 2004 @ 17:48

Link to this message

I played with the settings and still no audio I am going crazy what else can I be doing wrong? Thanks

[ + quote]

Start a new thread

afterdawn.com > forums > digital video > video capturing from analog sources > winfast tv2000 xp expert audio problems


		User name	Password

		Not registered yet? Register here. Lost your password? Click here.