I just installed a dvd rom drive under my dvd rw drive and am having problems making them work at the same time in unisen. My goal is to put a movie into the dvd rom drive and a bland into my RW drive and simply burn from one drive to another but I can't get to work.
If you are trying to copy a commercial/original DVD, I hope you realise that you cannot just copy without removing CSS protection and encoding/compressing the movie.
The typical installation would be to set the burner as master and the ROM reader as slave. I say typical because this works for most people. If you have problems with this setup, try reversing them. Depends on your mother board and other hardware you have installed. If you have two free IDE ports, you can make both of them master. If you don't know how to set them as master/slave, let us know. Hope this helps, keep us posted on your results.
No sorry, I don't know how to make one the master and the other slave. I could tell you this, the dvd rw drive was factory installed and is at the top and the dvd rom drive I just installed last night and is right below the rw drive. Hope this helps.
On the back of the burner, near the power connector, you will find a row of pins. Above the pins or on the drive label, it should show which pins should be "jumpered" (connected) to make the drive Master or Slave. If you make it Master, connect the end connector (not the middle one) to your drive. If you set it as Slave, you want to use the middle connector of the IDE cable. Hope this helps. Keep us posted.
