|
xecuter3 xboxv1.0 wd160hd thomson(is that how you spell it)
i installed chip and drive at same time.
didnt work. took out wire install re installed with pin header. got to blue screen. everything is good.have a hard time breaking through the bios barier. never flashed bios. it was always one stupped thing stoping me. my tv is blury, thomson doesnt kike memorex cd-r's, dont have a dvd burner,...
. i never even got to the loading screen. never got passed- install cd. never got passed- dchp adress.
all of a sudden...
blinking re/green after 3 etempts.
it fraged before i could flash it. i could see the external switch light up. lan= orange hd=blue x logo stayd blue wile the christmas lights blinked untill i shut it down.
ive clean up the conections the best i could without a pen or anything. just solderd better conections. now for the big moment...
accidentely i pressed eject.
it tried to boot three times wile blinking orange and green
i i tried it again and it did the same but this time i pressed the power button. i actually forget- but i think it blinked orange and green and stayd blinking orange and green.
next i brought it over to my tv and pluged it in to see if there was anything going on. this time when i pressed the power button it tried green 3 times again then stayd blinking red and green. nothing on the screen.
i then long press the power to start with original micosoft bios and bypass the chip. it starts rite up!
though it tells me i gota service my xbox, its cool cause i have a 160gb hd in there and it doesnt know it yet cause i havnt been able to flash anything at all yet. all this shit started before i could figure my bios stuff out. so i dont think i screwd it up flashing. i was messing with the network ip bios load and couldnt even get to the site were you select your bios. (its in the xecuter3 flash bios tutorial @ there site)
it craped the bed when i was messing with the network but i was unpluging and pluging new cords in the unit and mabey moved it,... maybe. i really dont think it happened at a sensable time. not after i did somthing or when i bumped it. just basically, as far as i can tell,on its own, like it just got board of being green.
when i press eject and power at the same time it goes purple (the xecuter logo) for basically as long as i prees it and then just goes red and my xbox starts up in reg MS bios mode(green)
wow, yah there yah go.. i wish i could get it working. care to enlighten?
cheers
Lucas
|
