Hello, I've installed the xecuter 3 CE on my 1.1 Xbox model and it boots good there are no flashing lights, the led light is green but nothing shows up on the screen.When I press the eject button, it turns off and on and I can't eject the DVD rom. Can someone help me?
hey i am having the same promblem with my xbox other then my led blinks green and red. i have went over the solder points and they all look good and tight but i also burned off one of my pads but i fixed that but it still doesnt work. can one of you guys help me. and no i wont trow my xbox away. my mod chip lights up with the bule lights. and the switch does to but it comes up with a red light for disabled i guess.
V1.0, WD 120gig HD, Xecuter 3 CE chip, Latest BIOS,
Front Control Panel, LED's, Cold Cathodes, Lighted controller ports, red eject LED, custom jewel with red neon ring, ATA166 HD cable
-Dashboards/Operating Systems: X3 Dash, EvoX, RemoteX, XBMC, UnleashX, Avalaunch, Emulators and much more
Well I went back and checked all the solder points again. made sure that i didnt do any cold solder or what not. they all looked good the places were i burend off the pads I put jumpers there. and it still doesnt work. i mean what else is there to do. i think i should just buy a new mother bored or a new xbox. but can you think of any thing else to do with it. if so wbs thanks
V1.0, WD 120gig HD, Xecuter 3 CE chip, Latest BIOS,
Front Control Panel, LED's, Cold Cathodes, Lighted controller ports, red eject LED, custom jewel with red neon ring, ATA166 HD cable
-Dashboards/Operating Systems: X3 Dash, EvoX, RemoteX, XBMC, UnleashX, Avalaunch, Emulators and much more
No i am not using a solderless adapter. but i think i am just going to go get a new mother bored probably new xbox because i think the mother bored i got is screwed up and so is the buttons to turn it off and on and open and close the close one ones but it doesnt turn off. so yeah. i am just going to get a new xbox
