Congrats on chipping your, but have you flashed yet. if not then you need to do this first, if you have, congrats agian because that could sometimes be the hardest part to do.
I assuming that you have flashed your chip already.
upgrading your HDD is very easy, but the easist way to do it is with a install disk like "slayers", if you dont have slayers, look for it, then burn it to a DVD-R, if you have it good.
Once you have slayers, you are going to need to reflash the chip so it supports the HDD you are installing. If your new HDD is bigger than 137 gb then you might need to reflash the chip. The slayers disk has all of the bioses you need depending on what you need. This step is only needed if the flash bios you have does not support your HDD
once your bios is ready, you are ready to upgrade the HDD. This is simple, insert your slayers disk, then power off the box, take out the HDD, replace it with the new one, then power it back on. if everything goes well you you should see the slayers menu again. What you are going to do next is tell slayers to do a clean install for an upgraded hdd, make sure you choose the option that installs everything. as a little note, if this HDD came from your PC and is not brand new, then you are going to have to reformat it first. Once all of this is done, you box should be good to go.
the harddrive is not qwhat gets flashed, you need to download the proper x2 bios and flash it to the chip, goto www.teamxecuter.com and follow the tuts you find, they are the x2.6 creatro and they know exactly whats happening
