|
Steps:
1. open xbox and remove motherboard
2. solder the chip holder to the motherboard, turn the motherboard over and solder on the back of the motherboard to connect the chip holder. use the www.teamxecuter.com tutorials. REMEMBER, YOU MUST REMOVE ONE OF THE PIN HEAD FOR YOUR XBOX VERSION 1.6B. THIS IS ALSO IN THE INSTALLATION GUIDE! READ IT CAREFULLY!
3. solder the hard drive, lan, DO wires to the LPC on the back of the motherboard. ( I remember as hard drive=red, lan=green, and DO=grey)
4. put the motherboard back into the xbox chasis and secure with screws.
5. solder the red +5v to the regulator chip on the motherboard, it's at the rear near the fan for version 1.6b
6. connect the eject/start button wires to the wire harness that came with your chip and tape it inside near the front.
7. remove the control port #1 and run a set of wires (came with your chip for the switches) through the front of the xbox. You will connect these wires to the switch panel and tape it to the front of the xbox. (2 sided tape is included on the panel.)
8. place the X3 chip into its holder tightly and start connecting all the wires to the chip.
9. put the xbox back together, hard drive, dvd rom, cables, etc.
10. turn on the xbox, will will see a blue screen that has the cromwell legal bios on the screen. If nothing on the screen or xbox is not booting, then you might have a cold soldered point or lose solder point. Take your time when you solder ok.
11. on the screen select the settings for network. you must connect the xbox to your router with DHCP. This is the easiest way to do it.
12. set the switch settings. sorry dude, I don't remember which settings for the switches. then go to your pc and where you have the 3294_16plus file, you will need to flash the bios with this file.
Now you are done and xbox is ready to ROX! That is when you are finished and after reboot, you will see the Xecuter icon in the middle of the screen at the bottom!
Remember all documents can be found at www.teamxecuter.com
Should take about 25 minutes to do this mod.
Good Luck!
cheers,
This message has been edited since posting. Last time this message was edited on 6. December 2005 @ 07:20
|
