Asus K8N nVidia nForce3 Pro 250 GB, Athlon 64 3200+, Hitachi 80 gig SATA 150, Corsair XMS 1 gig PC4000, ATI Radeon Saphire 9600 Pro (256 DDR), Windows XP Pro (64 Bit),Lite-ON SOHD 167T,, Plextor PX-712SA,BenQ 1640.
Error occurs when writing from a CloneCD image. During the lead-in burn the drive speed seems to hunt up and down, and then that error message pops up at about the point where it should switch to burning the data.
I read elsewhere that it could be an issue with poor media or poor recognition of media? So I tried writing the same image on same data at 4x - that worked.
So I'm wondering if either the drive or CloneCD is reading the settings for the blanks (DataSafe Silver Premium 40x 80 min) and attempting unsuccessfully to write at a high speed?
This might mean that when the program thinks it's time to shift to data-writing, the drive is actually only halfway through the lead-in (eg a long write is still in progress). I'm guessing here, as you might be able to tell.... :o)
Any idea or suggestions very appreciated. FWIW, blanks from the same pack *have* written successfully at high speeds previously.
