i modded my xbox,, but dosent work!!!!!!!!
|
|
chipper2
Suspended permanently
|
23. September 2006 @ 09:00 |
Link to this message
|
kk.,.,.
i modded my xbox with xecuter 2.6 on a 1.0 xbox....
but when i boot it with the chip enabled it turns on and off and when it does start there is no picture on the tv
and the led flashes red????
it boots fine when the chip is disabled....
please help
|
Advertisement
|
  |
|
chipper2
Suspended permanently
|
23. September 2006 @ 11:40 |
Link to this message
|
why!!!!!!
|
1337moder
Suspended permanently
|
23. September 2006 @ 15:42 |
Link to this message
|
1. stop reposting
2. your chip isn't installed correctly i had the same prob.
3. try reinstalling it and then if all else falls get a tut on your chip from the web
|
Venom5880
Suspended due to non-functional email address
|
23. September 2006 @ 18:37 |
Link to this message
|
Check all your solder connections. Make sure nothing's bridged and all the connections are solid and in the correct spots.
|
chipper2
Suspended permanently
|
23. September 2006 @ 22:32 |
Link to this message
|
ok,,,,,
i`ll have a go at it today
|
chipper2
Suspended permanently
|
24. September 2006 @ 01:44 |
Link to this message
|
solder points looks fine
|
1337moder
Suspended permanently
|
24. September 2006 @ 03:14 |
Link to this message
|
im telling u all u have to do is take it out completely
and reinstall it using the manual or a tut off the web,
My chip had dust or something between the connection points and wasent fully secure so u might have a similair prob.
|
Advertisement
|
  |
|
chipper2
Suspended permanently
|
24. September 2006 @ 04:11 |
Link to this message
|
kk....
thanks
|