|
|
|
burning vob, ifo, bup raw files to a dvdr
|
|
|
sans
Member
|
6. December 2006 @ 18:05 |
Link to this message
|
|
what program can you use to do this? i have a bunch of dvd files for a dual layer disc but i am not sure how to correctly burn them to a blank dl disc.
thanks for your help!
|
|
Advertisement
|
|
|
|
Senior Member
|
6. December 2006 @ 23:32 |
Link to this message
|
Well, if you have Nero, you could just start with a Video-DVD compilation. HOWEVER...
Since you're dealing with a double layer, understand that Nero and most other software does not handle DL burning well. You might get freezes at the layer break. The link below contains a guide to using PGCEdit to set the layer break proplerly and burn. The guide is a bit dated and newer versions of PGCEdit support IMGBurn and the menus are laid out slightly differently, but all the relevant stuff is there for you to do the job and do it right. Once you have PGCEdit set up properly, it just takes a couple of mouse clicks to open a VIDEO_TS folder, set the layer break, and burn. And you don't really have to do anything besides go through the motions.
http://www.digital-digest.com/~blutach/d..._pgcedit_v2.htm
-Do you believe you own your computer and shouldn't be told what you can run and do? Then say *NO* to Microsoft Vista!
-Since half the questions here involve media problems, here ya go: Only use Verbatim or Taiyo-Yuden discs (get your TYs from Rima.com, not Supermediastore or meritline). Forget the rest, no matter what "brand" they sell under. Always burn at 4x speed regardless of the speed rating of this discs or your drive. If you have burn problems with these then you have to update your drive's firmware. For double-layer discs, only use Verbatim DVD+R DL and burn them at 2.4x speed.
|
|
sans
Member
|
7. December 2006 @ 06:11 |
Link to this message
|
thanks for the reply.
before this thread i tried using Nero, but i put all the files in the video_ts folder and i ended up with no audio. burning process itself seemed to work fine tho.
which files go in the audio folder?
|
AfterDawn Addict
|
7. December 2006 @ 08:30 |
Link to this message
|
Quote:
which files go in the audio folder?
None.
|
Senior Member
|
7. December 2006 @ 12:40 |
Link to this message
|
You might want to preview the stuff you have on your hard disk with PowerDVD, Media Player Classic, VLC, whatever, to make sure they were ripped correctly.
-Do you believe you own your computer and shouldn't be told what you can run and do? Then say *NO* to Microsoft Vista!
-Since half the questions here involve media problems, here ya go: Only use Verbatim or Taiyo-Yuden discs (get your TYs from Rima.com, not Supermediastore or meritline). Forget the rest, no matter what "brand" they sell under. Always burn at 4x speed regardless of the speed rating of this discs or your drive. If you have burn problems with these then you have to update your drive's firmware. For double-layer discs, only use Verbatim DVD+R DL and burn them at 2.4x speed.
|
|
sans
Member
|
7. December 2006 @ 13:11 |
Link to this message
|
|
k ill try that, thanks.
also, curious about a couple things in your sig.
first off, why not buy the high def dvds?
second, is that line about terrorists a direct quote from dick cheney, or did you get that from fox news channel?
|
Senior Member
|
7. December 2006 @ 15:12 |
Link to this message
|
|
@sans:
That would be threadjacking to go into detail. I'll be happy to PM you some sources if you like on how they celebrated on November 8th or how HD/BR is just a big scam. I'd rather stick to the topic for now and the HD thing has been discussed previously by myself and many others in the HD forums. Start a thread there or use PM if you want to diverge onto other topics.
-Do you believe you own your computer and shouldn't be told what you can run and do? Then say *NO* to Microsoft Vista!
-Since half the questions here involve media problems, here ya go: Only use Verbatim or Taiyo-Yuden discs (get your TYs from Rima.com, not Supermediastore or meritline). Forget the rest, no matter what "brand" they sell under. Always burn at 4x speed regardless of the speed rating of this discs or your drive. If you have burn problems with these then you have to update your drive's firmware. For double-layer discs, only use Verbatim DVD+R DL and burn them at 2.4x speed.
This message has been edited since posting. Last time this message was edited on 7. December 2006 @ 15:45
|
|
sans
Member
|
7. December 2006 @ 17:49 |
Link to this message
|
|
gunshy much?
if you dont want a discussion, dont put it in your sig. it's my thread, i asked the question, obv dont mind if you "hijack" it answering a question of my own.
|
Senior Member
|
7. December 2006 @ 21:15 |
Link to this message
|
It's against forum rules. Perhaps you ought to read them sometime. I'd love to go into how the terrorists celebrated on Nov. 8 and give you sources from the radical left's own mouthpieces, CNN, ABC, AP, etc., but a thread on Dual Layer burning is not the place to do it. You may have started the thread on DL burning, and just because you're itching for an argument, doesn't mean you own the place.
Pay attention to all of them, especially #8
http://forums.afterdawn.com/thread_view.cfm/2487
-Do you believe you own your computer and shouldn't be told what you can run and do? Then say *NO* to Microsoft Vista!
-Since half the questions here involve media problems, here ya go: Only use Verbatim or Taiyo-Yuden discs (get your TYs from Rima.com, not Supermediastore or meritline). Forget the rest, no matter what "brand" they sell under. Always burn at 4x speed regardless of the speed rating of this discs or your drive. If you have burn problems with these then you have to update your drive's firmware. For double-layer discs, only use Verbatim DVD+R DL and burn them at 2.4x speed.
|
|
sans
Member
|
8. December 2006 @ 07:23 |
Link to this message
|
youre asking for an "argument" (your word) by toting that around in your sig. and you know it.
anyone in your family served in iraq?
didnt think so.
This message has been edited since posting. Last time this message was edited on 8. December 2006 @ 07:42
|
Senior Member
|
8. December 2006 @ 09:47 |
Link to this message
|
|
Half my friends are in either Iraq or Afghanistan. What about you? Didn't think so either. But this is another irrelevant topic - I'm sure next you'll bring up how President Bush is responsible for rainy days or the fact that there's no life on Mars. Wonder what other off-topic and pointless stuff you'll try to diverge onto.
Again, you don't own the place. I wonder what makes you think you do.
P.S. My apologies for trying to help you with your DL problem. My bad. End of line.
-Do you believe you own your computer and shouldn't be told what you can run and do? Then say *NO* to Microsoft Vista!
-Since half the questions here involve media problems, here ya go: Only use Verbatim or Taiyo-Yuden discs (get your TYs from Rima.com, not Supermediastore or meritline). Forget the rest, no matter what "brand" they sell under. Always burn at 4x speed regardless of the speed rating of this discs or your drive. If you have burn problems with these then you have to update your drive's firmware. For double-layer discs, only use Verbatim DVD+R DL and burn them at 2.4x speed.
This message has been edited since posting. Last time this message was edited on 8. December 2006 @ 09:59
|
|
sans
Member
|
8. December 2006 @ 10:41 |
Link to this message
|
|
you're obviously insane.
|
AfterDawn Addict
|
8. December 2006 @ 12:44 |
Link to this message
|
|
@sans
Please don't post obscene pictures.
|
|
Advertisement
|
|
|
|
sans
Member
|
8. December 2006 @ 14:20 |
Link to this message
|
Originally posted by MysticE:
@sans
Please don't post obscene pictures.
ha
|
|
