Shrink encountered an error and cannot continue.
failed to read file x:\ data error cyclic redundancy Data error
Possible causes are......
The disk is either badly scratched, diry/smudged in areas where info can't be read correctly, a bad press (digitally faulty), or copy protection shrink (or decrypter) can't handle because of its discontinued support/advancement.
-If the disk looks dirty/smudged, clean it, then try again.
-If it's copy protection that's causing shrink to spit out the error... then try any one of these options:
1) DVDfab decrypter, it's a very good and well supported free ripper/ decrypter. Use it to rip the video files to your HDD, open the files ripped using shrink and proceed as you normally would.
2) Ripit4me (nolonger supported), it takes the ripping/transcoding/and burning process and makes it a one click task. You'll need DVD Shrink, DVD Decrypter, and FixVTS (may not be needed in this version) to make it all work.
It's still around if you look hard enough.
3) Download and install the trial version of AnyDVD. Once installed, run DVD dhrink as you normally would to produce a backup, AnyDVD runs in the backround to crack the copy protection on the disk.
-If the disk is clean and any of the above methods fail, you could have a possible bad press, if so then you'll need to exchange it for another and try it again.
I got some (alot)advise from the everyone here and I thought I would pass it along.
I had the same problems and stated using DVDFab5 - FixVTS1.603 - dvdshrink3.2 - ImgBurn. In that order.
It worked great.
CC
Originally posted by ZoSoIV:do not past go do not collect 200.00 dollars and go directly to jail if you start asking questions before you read the info/guides in both links below
