|
Toshiba/samsung Ts-h943 Drive Grinding But Working
|
|
|
Keerimen
Suspended due to non-functional email address
|
22. February 2009 @ 16:12 |
Link to this message
|
|
My 360's drive was stuck for the longest time, got it unstuck and it works! This is the problem however; the tray opens clunkily, slow and sounds like it could be coming out and in smoother. And, when the disc stops spinning, I hear grinding as the disc spins down!
Like I said, it works, doesn't seem to be scratching my games either, but I have no idea what to do! Any help is appreciated.
Thanks!
|
|
Advertisement
|
 |
|
|
AfterDawn Addict
|
22. February 2009 @ 17:36 |
Link to this message
|
my old samsung had the same issue, and I ended up having to replace it.
need jtag help? Xbox 360 console repair? PM me or chat |
|
Keerimen
Suspended due to non-functional email address
|
22. February 2009 @ 19:17 |
Link to this message
|
|
I find you can feel the tension when the drive belt is attached, but when removed and the tray slid manually, its stops.
|
|
Keerimen
Suspended due to non-functional email address
|
22. February 2009 @ 20:26 |
Link to this message
|
I lubed the whole track of the DVD, and cleaned it, a hell of a lot.
The grinding when the disc spins down has stopped, but I'm still getting that odd, best I can describe it, struggling, friction-y, movement of the tray when ejecting and back in. With the lube, it does it less. I've also noticed that the belt seems to be pull the gear its attatched to, toward it, so instead of being nice and flash, its at a very small angle.
Any ideas?
|
|
ajennice
Junior Member
|
23. February 2009 @ 00:45 |
Link to this message
|
replace it. It's a spiral type gear inside. This pushes and pulls the tray in and out and raises/lowers the dvd laser and inner workings. The grind, if the magnet is still on, is the spinning piece not getting high enough to have the disk clear the tray 100%.
get a new drive and kget it spoofed.. this way you know you're good for a while
|
Senior Member
1 product review
|
23. February 2009 @ 00:49 |
Link to this message
|
|
no need to spoof, just get another drive like you have and put your pcb board from your old drive in your new drive.
|
|
Advertisement
|
|
|
Senior Member
|
23. February 2009 @ 01:50 |
Link to this message
|
|
i havent seen a drive yet that doesnt make these noises . and i have to tap/smack the front of all my 360s to open the tray. if i have opened it and put a disc in a played some then it will open fine after that usually but if i move the console any i have to get it unstuck again
If you send me questions on Live about modding or anything related i will block you. Dont be an idiot.
|
