Im trying to flash my hitachi v47, Im using x360usb pro with connection kit 3, I get the drive into mode B using jungle flasher, By following the tut, I then keep following to the point of clicking read from source. At this point my jungleflasher freezes (mode select option) or says ram poke failed (ram upload option) then goes into not responding.
I have the same exact drive, I just hooked it up to my sata port in my PC, and jungle flasher wouldnt even read my drive even though ive flashed it the same way before, the only difference was that i used the newer version of JF, when i used an older version of JF like i did before it worked fine, i would suggest just hooking it up different and trying different ways to flash it.
Originally posted by blowe3711: My computer detects the drive, goes into modeb, just freezes when I press read from source
This means you don't have a via chipset or you don't have it setup right. Freezing is always the satadriver issue. You need to disable them in windows like the guide says.
Originally posted by blowe3711: My computer detects the drive, goes into modeb, just freezes when I press read from source
This means you don't have a via chipset or you don't have it setup right. Freezing is always the satadriver issue. You need to disable them in windows like the guide says.
Originally posted by blowe3711: My computer detects the drive, goes into modeb, just freezes when I press read from source
This means you don't have a via chipset or you don't have it setup right. Freezing is always the satadriver issue. You need to disable them in windows like the guide says.
I'm using x360 usb pro, this isn't my problem, its been a few wks and still haven't figured this out.
Originally posted by blowe3711: My computer detects the drive, goes into modeb, just freezes when I press read from source
This means you don't have a via chipset or you don't have it setup right. Freezing is always the satadriver issue. You need to disable them in windows like the guide says.
I'm using x360usb pro to detect drive
make sure you have winapi selected and drive powered on when you open JF... I had one do this before. you have to make sure your drive is showing up in the right hand side of JF not just the left side..make sure you scan for hardware changes on the right after setting mode b. ( i recently switched to the 360usb) I can't say how much easier it is w/o worrying about all the b.s. with an onboard chipset i used to use.. Crashing, freezing, ect.. also make sure you have usb selected under second tab, unselecte everything else.
