|
Who Ever Needs Help With X3 Go Here.....
|
|
|
theridges
Suspended due to non-functional email address
|
17. August 2006 @ 09:20 |
Link to this message
|
I have seen a lot of people confused on how to flash/Install the X3 so i have put together Some things for the People who need help flashing the chip and have also put the link for the X3.pdf direct from Team-Xecuter for people who are to lazy to look for it....
(This is Copied Directly from the PDF and i Take No Responsibility for Writing This Copright -Tehsoul)Link to PDF is at the bottom of the page.
Before you rush out to install applications
There?s some things you need to know about the X3(CE) modchip and its functionality
First of all? The boot modes
I?m not sure if I should give you any additional information, since the picture is quite self-explanatory.
The only things you need to remember are:
· SHORT PUSH: chip enabled
· LONG PUSH: chip disabled (boots to M$ Dash, use this for Xbox Live usage)
· PUSH BOTH BUTTONS: boot to a backup Flashbios, in case you ever screw up,to reflash the bios..
When you got the X3CE in your mailbox, it was preflashed with Flashbios. The following is a quote from
the flashbios tutorial found at http://www.teamxecuter.com/flashbios/ (read this for more in-detail info):
Quote:
FlashBIOS is a utility to update your modchip with any other bios. You cannot play games or run unsigned software with this
bios. If you want to run unsigned software you must download a hacked bios like X3 Bios, X2 Bios or Evox Bios. These are
illegal and we do not provide direct links. Read this page for info where to find hacked bios's http://www.xboxscene.com/articles/xbins.php
Bottom line, you need to flash your X3CE bios with a hacked bios if you want to play backups/run
unsigned code like homebrew applications and games.
Your X3CE modchip has 2MB of main flash memory to hold the bios
(a typical X3 bios is 1MB, so you can fit two of them if you want).
If you use an external switch to control your bios banks, print this out and pin it above your bed:
256k Bank
Bank 1: on on on on
Bank 2: off on on on
Bank 3: on off on on
Bank 4: off off on on
Bank 5: on on off on
Bank 6: off on off on
Bank 7: on off off on
Bank 8: off off off on
512k Bank
Bank 12: on on on off
Bank 34: off on on off
Bank 56: on off on off
Bank 78: off off on off
1MB Bank
Bank 1234: on on off off
(Set to this when flashing
first time with FlashBIOS)
Bank 5678: off on off off
2MB Bank
Bank 12345678: off off off
off"
?But wait?, you might think. ?My switch has 5 dipswitches, not 4!?. Correct sir! The fifth (lowest) switch
is for flash protection. If that switch is enabled, you won?t be able to flash to your bios memory.
Pretty neat, eh? Foolproof all the way baby.
Anyway, if you succeeded at flashing the bios (I recommend the http flashing, it?s a breeze), here?s some
applications for the xbox that are definitely worth looking at:
· Xbox Media Center (or XBMC): very popular media player. Plays just about ehm, everything.
· Avalaunch: Easy to use and versatile ?dashboard? (launcher).
· Dvd2xbox: Application to backup your games to the hard disk drive.
· XLink Kai: Tunneling software, makes you able to play systemlink games over the web!
· Any emulator: there are tons of emulators for the Xbox platform
(ranging from ancient Atari 2800, NES to MAME, Nintendo64 or even Playstation1)
http://teamxecuter.entryhost.com/x3ce.pdf
*Dont ask me For Bios's Go To Xbins here is a tutorial on how to connect to Xbins*
http://forums.afterdawn.com/thread_view.cfm/368866
How to connect to #Xbins Tutorial -*With Pics*-
This message has been edited since posting. Last time this message was edited on 17. August 2006 @ 10:53
|
|
Advertisement
|
|
|
|
|
noobz
Suspended due to non-functional email address
|
22. August 2006 @ 09:35 |
Link to this message
|
|
i did the quick press with my xecuter and it still shows me the service sign. please help me load it to the modchip. the modchip is alwys red and i cant get it to go blue.
|
|
theridges
Suspended due to non-functional email address
|
22. August 2006 @ 11:46 |
Link to this message
|
|
make sure the flash protect on the chip itself is off...that might be the problem....
|
|
noobz
Suspended due to non-functional email address
|
22. August 2006 @ 18:29 |
Link to this message
|
|
can that mess up my xbox's flash
|
|
theridges
Suspended due to non-functional email address
|
22. August 2006 @ 19:27 |
Link to this message
|
|
well even team-xecuter says turn that off and use the external switch so i guess ya....
|
|
noobz
Suspended due to non-functional email address
|
22. August 2006 @ 19:45 |
Link to this message
|
|
it has a error 05 on the left top.
|
|
theridges
Suspended due to non-functional email address
|
22. August 2006 @ 23:11 |
Link to this message
|
|
your HD is unlocked just load up AID 3.0 and lock it back....and make sure your booting with a Quick press so you enable the chip...because the X3 bios should overwrite Error 5..
|
|
noobz
Suspended due to non-functional email address
|
23. August 2006 @ 03:06 |
Link to this message
|
|
sorry for triple posting . i am new so it you could walk me through the whole thing it would be very helpful. can u give me some links from where i can download these stuff. one more i do a quick press still no loading up the chip i think i do have a executer 3. thanks bro
|
|
noobz
Suspended due to non-functional email address
|
23. August 2006 @ 03:08 |
Link to this message
|
|
sorry for triple posting . i am new so it you could walk me through the whole thing it would be very helpful. can u give me some links from where i can download these stuff. one more i do a quick press still no loading up the chip i think i do have a executer 3. thanks bro
|
|
theridges
Suspended due to non-functional email address
|
23. August 2006 @ 10:33 |
Link to this message
|
|
make sure the chip light is on.....your chip isnt booting for some odd reason...
|
|
noobz
Suspended due to non-functional email address
|
24. August 2006 @ 16:20 |
Link to this message
|
|
i know that's why i am asking if you can help me load it.
|
|
theridges
Suspended due to non-functional email address
|
24. August 2006 @ 16:56 |
Link to this message
|
|
i dont know why your chip isnt booting right the only thing i could think is that the D0 wire isnt hooked up right..
|
|
reaper117
Newbie
|
27. August 2006 @ 15:52 |
Link to this message
|
|
hey on a random note my is doing the same thing and i have desoldered it and re soldered it with less solder and i have my D0 cable installed and well i need to know if i can desoldered it and use a solderless adapter.....
|
|
theridges
Suspended due to non-functional email address
|
27. August 2006 @ 20:23 |
Link to this message
|
|
yes u can desolder it and use the solderless adapter but make sure all the solder is removed....
|
|
reaper117
Newbie
|
28. August 2006 @ 13:08 |
Link to this message
|
|
thanks for that info i am now buying me a solderless adapter!!! ^_^
|
|
help12345
Suspended due to non-functional email address
|
4. September 2006 @ 21:45 |
Link to this message
|
|
do u think u cld walk me through on how to lock my hd. and i also forgot to plug on controller ports 3 and 4. if u cld help me with that
|
|
theridges
Suspended due to non-functional email address
|
4. September 2006 @ 22:10 |
Link to this message
|
lol yea,
first go download Aid 3.0 or search config magic on google.....
ifyou get AID 3.0 and burn it on dvd config magic is in the tools section just open it and lock the hd...
if you download the program by itself just just FTP it to the xbox and open it up....its a very simple problem...what chip do u have exactly???
and i have no clue about the contrller ports.
|
|
annjee
Junior Member
|
18. January 2007 @ 19:51 |
Link to this message
|
|
Alright, I could really use a lil help here. I have a new hard drive locked with the wrong hd key and I don't know how to discard that key and start fresh. SO I bought a X3 ce and a soderless adapter. I got that in there and thought it was working cause I can get to the x3 bios screen. I flashed it by disc with x3-3294. It turned off on it's own and when I turned it back on it acts like it's trying to start three times and then I get FRAG.
Your help is appreciated.
|
|
theridges
Suspended due to non-functional email address
|
20. January 2007 @ 13:19 |
Link to this message
|
|
What Xbox Do you have???
make sure your switches are on the right settings to flash the bios to bank one.....
to re-flash thechip press the eject and power buttons at the same time to reflash :)
|
|
annjee
Junior Member
|
23. January 2007 @ 18:10 |
Link to this message
|
|
Thanks for the reply. Instead I used the chips built in bios program to lock the hard drive. Then I soft modded it and took the chip out. Works perfectly!
|
|
theridges
Suspended due to non-functional email address
|
26. January 2007 @ 12:44 |
Link to this message
|
|
whatever works for you :)
|
Newbie
|
27. January 2007 @ 00:10 |
Link to this message
|
|
i just installed the ce chip no problem and i tried to install the hacked bios and followed the instructions to a "T" bfrom xbox-modchips.com but now after i flashed and then turn it back on the xbox turns on and off three times and the remains on flashing red and green, please help
|
|
theridges
Suspended due to non-functional email address
|
27. January 2007 @ 23:18 |
Link to this message
|
|
what version xbox do you have and what bios did you try to put on there?
the newest bios is the 3294+ but you have to make sure its the right version for your xbox...
|
Newbie
|
28. January 2007 @ 09:55 |
Link to this message
|
|
i have three different kind 1.0's and a 1.1 we are trying it on a 1.1 right now and then getting the error, also i can switch the banks and the chip boots up fine. i even tried to unsolder and then resolder. and same thing, O and with the X3CE chip can you load any flash bios or just the X3 flashbios, Thanks I really appreciate it
|
|
Advertisement
|
|
|
|
theridges
Suspended due to non-functional email address
|
28. January 2007 @ 11:05 |
Link to this message
|
|
to reflash the bios, press the power and eject button at the same time...and the flash bios is the only option to reflash the bios.....click my name to download the bios pack make sure you use the 3294+ not the one for the 1.6....
|
