X3 CE chip problem

Advertise at AfterDawn.com

Link to us!

Private messages

Compose a private message

List of all updated threads

Threads without replies

Search messages

Tuesday 26.11.2024 / 10:52

Search AfterDawn Forums:

afterdawn.com > forums > archived forums > xbox - hardware boot discussion > x3 ce chip problem

Browse by topic

Forums

X3 CE chip problem

Jump to:

Posted

Message

Stabby

Member

17. April 2007 @ 20:02

Link to this message

Hi folks,

I have a V1.1 Xbox that I just installed the X3 CE chip, X3 Control Panel, and the X3 IR usb programmer. On power up, the chip's LEDs do not light up. The Xbox boots as if no chip is installed. While power is on, The IR mod had a blue LED that is on. On power off, one of the mod chip's LEDs flashes blue.

I believe I have a bad chip. I've checked and double checked the D0 wire, no wires are pinched, and all connections are good.

Any ideas?

This mod chip package came from www.mod-chip.com . When I began the install, I noticed that the external switch, IR main board, and the USB adapter board all had sticky pads on the back for securing to the inside on the console. All of the sticky back backing was missing. Most of the "stickiness" was worn away and not sticky anymore. I am suspecting that this is used equipment....Thoughts?

[ + quote]

Mod your gaming console today!

casper007

Suspended due to non-functional email address

18. April 2007 @ 13:59

Link to this message

send it back for a replacement, i have bought chips from them guys and if you call them they can be very helpful.

[ + quote]

Casper007

afterdawn.com > forums > archived forums > xbox - hardware boot discussion > x3 ce chip problem


		User name	Password

		Not registered yet? Register here. Lost your password? Click here.