afterdawn.com > forums > consoles > nintendo wii - general discussion > cyclo wiz install help
Cyclo Wiz install help
madcam2
Newbie
29. April 2007 @ 13:24
Link to this message
installed my chip last week and tested and got a solid green LED on.
No problems i though,
Got two ISO files, which look have been dumped okay and are the exact byte size.
But after buring both at 1x speed the backups still wont load, as the come up with disc errors. My Originals work no probelm.
At advice would be appriciated.
Advertisement
Thinone
Senior Member
29. April 2007 @ 14:10
Link to this message
try different discs
and use imgburn to burn the isos
when u dumped them u did convert from wii to iso didnt u?
madcam2
Newbie
29. April 2007 @ 23:30
Link to this message
Tried a few different media, and with Imgburn.
But still no joy.
Downloaded the two image files ( i have the original of course), but not the correct drive to dump them.
When you dump a disc using Rawdump, does the file come out at 4,699,979,776 bytes or is that only after it has been coverted to ISO.
I'm not sure if my ISO's are good.
Would NTSC games work on a chipped PAL console?
ghostboy6
Member
30. April 2007 @ 07:31
Link to this message
some games would work on a chipped PAL console (there are still some compatibility issues) check the properties of your iso its file size should be 4,699,979,776. i advise using verbatim DVD-R or tayo yuden DVD-R as it has been compatible with most people. If it doesnt work with you try different dvd media like maxwell or sony.
Advertisement
Thinone
Senior Member
30. April 2007 @ 09:10
Link to this message
which NTSC games are you trying to play
try looking here
This message has been edited since posting. Last time this message was edited on 30. April 2007 @ 09:11
afterdawn.com > forums > consoles > nintendo wii - general discussion > cyclo wiz install help