Originally posted by Btard:

---

Today i have installed my wiiky using the wire method and i triple checked to see if i did it right, But for some reason config 1.2 wont show on the menu,idid the bath for usa then i burned the iso using Imgburn At 1x then 2x then 4x four dvds i went through And its still not working> im Using maxel DVD-R (up to 8x 4.7 gig) I have also ordered some verbatim DVD-R from newegg.com

heres a everything in a nutshell

-Wiikey installed properly
-Wont boot
-Maxel DVD-R 8x 4.7 gb
-using imgburn at 1x 2x 4x
-Used usa batch iso from config 1.2
-boots legit wii and gamecube games
-Bought from here

Could it be my media?

Or my burn rate?
[i]
Or is it a fakechip?[/i]


Any help would be most appreceated.

---

Originally posted by k13n:

---

Hey I had the damn bloody same problem as well - when I ran DOS prompt to create the ISO (tried just double click as well - on batch file) for some what reason the ISO image came out only 4.5MB well that is too tiny. That could be one of your problems see if the ISO image is more than 1GB - 4.3GB.

I read some where "if you are using windows XP it will have a few issues creating the ISO image" also wiikey support department are lazy buggers I have sent an email like 2 weeks ago regarding this issue and no response also the chip firmware update is supose to be out, where is it? So I might just change to a wiid as most people are saying this is the next best thing or even better with a good support department, already de-soldered wiikey, mite sell my PAL wii and get a NTSC-U/J version, I want to play Naruto and Bleach these games kinda loaded with the wiikey but stayed on a black screen and that was all.

Also if you are looking to play other region games check the compatability list here http://wiki.gbatemp.net/index.php/Wii_Re...y_List#See_Also they also have some info regarding changing an PAL ISO image to JAP and so on.

---