|
Hello,
I have recently bought a BTC DVD +/- Recorder, model DRW1004IM, I burnt my
first DVD RW no problem about 4.0GB consisting of 4 VHS Film Transfers.
The next DVD is where I encountered problems, I tried to back up about 4.3GB
of data from my Hard Drive organised into folders, I used a "Sky" DVD+R and
NERO 5.5.10.33, which came with the Drive. After a few complaints about
naming conventios and depth of folders, which I ammended, the DVD burnt away
very slowly though, about 15 / 20 mins.
NERO reached about 99 percent and started the lead out stage and BINGO The
message "Could not perform end of Disc-at-Once".
I have scoured the Net and found lots of examples of this that state that it
is a NERO compatability problem, one post said that versions of NERO 5.5 and
6.0 have the same problem and to use 5.5.10.42, which I could not find on
the NERO site so I downloaded 5.5.10.54 the latest version of NERO 5.5.
I have since found NERO 5.5.10.42 but have read another post saying that
this has a similiar problem.
I have also read that this problem appears with some Plextor Drives using
NERO and I have read somewhere that the drive in the BTC may actually be the
same as a Plextor, is this true?
Anyway before I waste money and start a coaster production line I need to
know:-
Which version of NERO should I use?
Should I upgrade the firmware on my DVD Burner? I have downloaded V043 from
the BTC site but they state not to upgrade if the drive is working which in
theory it probably is!!
Thanks in advance
Bill H
This message has been edited since posting. Last time this message was edited on 3. November 2003 @ 09:54
|
