Dolby Surround was invented circa 1977 for the Lucas film 'Star Wars'.
The simple system sent LeftMinusRight (the so-called 'difference' signal) to the surround channel, typically two speakers, but one channel.
Home-theatre guys in the 1980s quickly figured that L+R gave a 'centre' channel (using perhaps the built-in speakers of the TV monitor) so there you go, home theatre!
Dolby Pro Logic is basically the same thing, with enhanced separation Front to Rear (up to 30dB) and a formal centre channel using dialogue-steering logic, and adding the ability to generate test tones.
This technique decodes channels matrixed into a standard stereo audio signal, L & R. So any stereo music will give a pleasing effect with ProLogic playback.
(Getting to the point) Dolby Digital is a whole other thing! A discrete system of 5 channels plus a dedicated Low Frequency channel = 5.1
Notably, there is 100dB+ separation between all channels (including L & R surround).
5.1 audio isn't mixed down into L & R like before, and I am unfamiliar with Dolby Digital MP3s.
So basically just play everything through your Sony and enjoy the surround channel! The centre channel is optional, recommended only for viewing films, and might seem to reduce the L to R separation in music.
If you have a nice (shielded) centre speaker, then WTF just place it close as possible (above or below) your monitor, and enjoy!
Tip: run your test tones and adjust the C channel volume so it is subtle, not overly dominant.
Regards
ABit AB9 Pro
Intel Core 2 Duo E6420 @ 2.4GHz
2GB OCZ PC2-6400 Platinum XTC R2
ATI Radeon X1900XT 512MB
Enermax Liberty 620W
320GB/16MB WD, 150GB/16MB Raptor
Plextor PX-755SA DVD (SATA)
|