|
Have you tried different media or is this one batch of media.If it is one batch of media maybe it may be faulty media.Have you ensured you DMA is set to on for your writers.This can be found going in to control panel under systems then diver management and you should be able to check under the propertys of each drive.Also if you have installed different burner have you ensured you have the master and slave setting correct.
If you have a writer running off the same ide lead as your hard drive this should then be set to slave.If you have both writers installed on a seperate ide lead to that of the hd then one to master and one to slave.
I would do the following as it is probably something small that needs a slight alteration.
1. Try a different media if you have not already done.
2. Ensure all your drivers are connected up to your ide leads correctly and set correctly.
3. Ensure the DMA is switched on.
4. When your sure all of this is corrct re install your burning software one by one.Some burning softwares can cause conflict with others causing both not to work so do one by one and testing each as you go along.If all this is right you should not have a problem then.If you do just ask for more help myself or someone else will be on hand to help.
i9 9900K CPU,ASUS MAXIMUS XI HERO Mobo, Fractal R6 Case,
Corsair H115I ,Corsair RM Series 850W psu,
RTX 3080 Ti ,Corsair DDR4 Vengeance RGB PRO 32GB 1TB Intel SSD 660p Series,1TB M.2 ,36TB Seagate HD,19TB Ext, LG BH16NS40 BD-RW,Creative Sound Blaster Zx 116dB Sound Card, Acer Predator XB321HK 32inch 4K Monitor, 2TB PS4
|
