ok my problem is i put in my Mod-chip (solderless version)like im supposed to i think. but when i try and boot my xbox for the fisrt time after install the light go's green then blinks red/green. I've moved the chip around but no luck. Also there is no error message jus a black screen. What do i do now, or did i miss a step. All i installed was the Adapter and the chip itself as hardware. not the xtra wires it came with. And the LED on the chip is Solid RED. !!PLEASE help!! :(
When the light on the Xenium is red, it usually means a bad d0 connection. Check to make sure it's secure. I had the same problem with the red LED always on. Turned out that I had to solder a wire between pin 4 and the d0 pin on the adapter to get it to work.
Another thing to check: You say you have a v1.0 mobo. Check the LPC and see if the holes have solder in them. I read somewhere that the 1.0 motherboards had solder in the LPC. If so, you may need to wick the solder out before seating the adapter.
I agree, it's your D0!! If your the D0 wire were in correctly you would get the Xenium OS. Like MW just said, wick out some solder from the LPC or File the pogo pins on the adapter just a little and clean them with alcohol. I have a 1.0 and yes the LPC holes were filled at one point.
My current systems :)
V12 DMS4 Lite with summ0ne fix
Xbox 1.6 - Xecuter 3 w 300GB HDD
Xbox 360 - Sammy Drive with ixtrem 1.2
Wii Rev 1.0 - Authentic Wiikey
Be sure to use the summ0ne fix on your v12 !
http://www.cellexmods.com/v12install/Picture21.jpg
I agree Spyman!!! I installed a Xenium Ice solderless for a buddy of mine and he had a 1.0 and the new solderless adapters do make really good contact. The adapter did not start to lift up from the other end like the old ones did. These adapters are getting alot better now!!
