Hey guys - finally got streaming working - but needin a 100mbit loader - i tryied GCSIM but when starting it on 100mbit full duplex all i ever get is intialization errors.
try it again few times and it works, if still not, try to tweak everything, if still not work, get router or better network card, or use older gcsim loader that has no initialization feature.
The future is not set. Theres no fate but that which we make for ourselves. Oon Consoleforumsin mysticy, PS2-Scenen MysTiCy ja Maxconsolen toad86.
Modailen PS2, Wii, Gamecube, Nintendo DS. Porissa. Asentelen jälleen FreeMCBootia :)
Super Nintoaster! :D https://sites.google.com/site/markosstuff/super-nintoaster
It is your NIC
I had the same prob.
Either get a new NIC or go buy a network switch or a router. I got one for $10 at Fry's. With this method you do not use cross-over cables.
S3-GCSIM works great for me now NO init erros at ALL!
Good Luck
Gamecube: NTSC DOL-001 REV A - BIOS Rev 1.1 - Drive Model 04 2002/02 (61) - LaserPot = 183 ohms now tweaked to ~150
Mod Chip: XENOGC
Soft Mods(replaced by xenoGC, but still useful!): BBA, AR 1.07, SD Adapter, Samson's Loader Mem Card - GcoM2.3 for ripping
Burner/Media: NEC2100 (flashed to 2510) / Office Depot mini, Teon full size
GCSim works awesome here. Looking on my router, I see it is in 100mbit mode. Transfers are much faster, too. The only problem I have is that I hear a buzzing noise every time data is transmitted. Anyone else get this? It used to be the music would stream slowly, but whenever data is transmitted, I hear a buzzing noise.
The future is not set. Theres no fate but that which we make for ourselves. Oon Consoleforumsin mysticy, PS2-Scenen MysTiCy ja Maxconsolen toad86.
Modailen PS2, Wii, Gamecube, Nintendo DS. Porissa. Asentelen jälleen FreeMCBootia :)
Super Nintoaster! :D https://sites.google.com/site/markosstuff/super-nintoaster
This message has been edited since posting. Last time this message was edited on 28. March 2005 @ 12:02
Gamecube: NTSC DOL-001 REV A - BIOS Rev 1.1 - Drive Model 04 2002/02 (61) - LaserPot = 183 ohms now tweaked to ~150
Mod Chip: XENOGC
Soft Mods(replaced by xenoGC, but still useful!): BBA, AR 1.07, SD Adapter, Samson's Loader Mem Card - GcoM2.3 for ripping
Burner/Media: NEC2100 (flashed to 2510) / Office Depot mini, Teon full size
Yes, the BBA can do 100Mbit. One thing you have to keep in
mind is you can't lock your PC's NIC card at 100Mbit. It has to
be set to autodetect, or use a 10/100 hub in between your PC
and GC.
PSO starts out at 10Mbit, and then GCSIM switches it up to
100. Some PC NIC cards may have problems detecting the
change, or switching from 10 to 100 fast enough (Just
guessing here.)
GCSIM is much faster than previous loaders, however as many
have pointed out it can't give you a full 100Mbit because of
gamecube limitations.
