PS2 Front Cover Clips

Junior Member

6. June 2006 @ 12:33

Link to this message

Can anyone show me a picture of what the PS2 Front Cover Clips look like?

AfterDawn Addict

7. June 2006 @ 04:02

Link to this message

i probably could if i knew what you were talking about?
What version?
http://www.teammodders.com/viewtopic.php?t=2903
http://www.teammodders.com/ps2_tutorial.php?ex=2#18

Junior Member

7. June 2006 @ 06:06

Link to this message

I have a v7, and what are the clips for? and how could i put the clips back on? if they broke off

AfterDawn Addict

7. June 2006 @ 10:01

Link to this message

Like i said, what clips are you talking about?
are you talking about the cover for the DVD drive?
where are the clips you are talking about located.
Do you have a picture?

Junior Member

7. June 2006 @ 13:34

Link to this message

The clips for the Disk Tray, sorry for not answering ALL the questions. And like i said on my last post, if they broke off how can i put them back on, and what are they for?

iPirate

AfterDawn Addict

7. June 2006 @ 15:03

Link to this message

Are you talking about the strip of plastic across the cd tray which comes out when you hit eject and has the rotating ps2 logo. And that you have to remove to use the swap card?

Junior Member

7. June 2006 @ 23:40

Link to this message

Yes. What do the clips on it look like if its a v7 PS2 and if they break off how can i put them back on?

AfterDawn Addict

8. June 2006 @ 05:05

Link to this message

last i knew they were just little plastic pieces that hold it in place. You break them and there is no way to put it back on.
If removing it you need to be VERY careful.

Junior Member

8. June 2006 @ 23:52

Link to this message

What if i get a Flip-Top Case? Will i need those clips for the flip-top case? BTW, are flip-top cases easy to install?

AfterDawn Addict

9. June 2006 @ 03:37

Link to this message

the flip top case will not effect the disc tray at all.
It is a whole new top half of the PS2 case.
And yes it is pretty easy.
Just a few screws, then take the power/eject button off the old top and stick it on the new opne, then put it on and put the screws back in.
Be carefuk when doing this because too many people take the case top off and pull out the power/eject ribbon because the button is connected to the top and to the PS2 bottom by a silver ribbon that you can not pull on or damage.