is there a way or trick how to remove the waranty stickers from the wii?
maybe some pictures where exactly they are?,,
so the waranty does nt get void...
thanks
I couldnt get those to restick after modding the wii so my screws are still exposed. I also ended up with an extra screw after putting it back together and was never able to figure out where it belonged. But everything works great so I cant complain.
Originally posted by penguin98: Oh, the white screw cover stickers.
I couldnt get those to restick after modding the wii so my screws are still exposed. I also ended up with an extra screw after putting it back together and was never able to figure out where it belonged. But everything works great so I cant complain.
What does the screw look like and I'll tell you where it goes ;)
There is some places on line sell new sticker/pad sets.
Just incase this is usefull to anyone heres whats needed to open the wii.... You'll need a small phillips and triwing screw driver set, Like this
1 - Remove the 2 flaps
2 - Under the flaps is a black face plate, in there is 3 tiny phillips screws. Remove them and the face plate
3 - Under the black face plate you will find 2 x silver triwing screws, remove them.
4 - On the other side (battery side) remove the battery and reveal a silver triwing screw. Remove that.
5- On the same side, lift the rubber pad at the front to reveal a small black phillips screw - remove that.
6- Again on the same side along from the batter cover is a white square sticker, remove the sticker to reveal a silver triwing screw. Remove that.
7- On the underside of the wii there is 2 rectangle rubber pads at the back, remove them to reveal 2 x silver triwing screws. Remove them.
8- On the same side near the front is 2 x rectangle white stickers, remove them to reveal 2 x black triwing screws, remove them.
9- The front panel will now come off, watch for the wire that will need unplugged.
10 - The case will now pull apart and you'll see the drive.
11 - To remove the drive you'll need to remove the small silver screw in each corner using a small phillips driver.
12 - Once the screws are out, caefully remove the drive. 1 cable will need unplugged, the other is a ribbon cable. To remove the ribbon cable, open the little flap on the connector.
