I had just had my wiikey 2 professionally installed and im having a problem. The wii powers up fine, but will not intake or load a disc. its almost as there is no power going to the motor. I even tried inserting a disc with the power off and the wii will not load it nor eject. There is a solid red light on the modchip and the chipset I have is d2c. Can someone please help...
I installed my wii key2 myself, and have a similar issue. Sometimes when swapping disks the drive will not start the motor to insert the disk. If you do a power cycle on your wii it resets the drive and your able to insert the disk. If you have a solid red light then I would send it back to get repaired.
The problem sounds like your modchip is not recieving a proper clock signal from the drive. Try resoldering your clk point (point G on the wiikey II) at both ends. Beyond that I would suggest you contact the person who installed the chip.
hey i fixed two for my friend like that , you will need to resolder the round wire (-) or G wire fisrt if it not work check all the rest of wires , on of them has a cold solder joint, hope it help
Hi fellas. I'm getting nowhere fast. I've installed my wiikey2 w/ wii-clip and some backups don't work. I would say closer to %40 of the old backups don't work.
I have 2 systems, the other i have d2pro w/ wii-clip and all backups work. no problems, ever.
but I just can't figure out why some do and some don't with this wiikey2 ? is this the cheap one or something? i'm using the latest v 1.2 ...
