installing xecuter 2.3 lite+

Advertise at AfterDawn.com

Link to us!

Private messages

Compose a private message

List of all updated threads

Threads without replies

Search messages

Friday 8.8.2025 / 09:52

Search AfterDawn Forums:

afterdawn.com > forums > archived forums > xbox - general discussion > installing xecuter 2.3 lite+

Browse by topic

Forums

installing xecuter 2.3 lite+

Jump to:

Posted

Message

zeroskull

Newbie

20. February 2004 @ 18:43

Link to this message

im following the guide, my lpc ports on my motherboard are filled with sodder. Do i need to remove it and how? Its because i have one of the first xbox's..thanx

[ + quote]

You sold my dead bird to a blind kid?
he, he didn't even have a head.
Harry...Don't worry... I took Care of it = )

ten80

Junior Member

23. February 2004 @ 08:50

Link to this message

I didn't and i have the 1.2 version of an xbox...all I did was plop it in and it worked. The only thing i found weird was when i installed my chip i had the proper alignment and i was getting power from the bus so both blue lights where on. But my d0 contact LED only flashed green for the first 3 seconds of boot up...but it still works regardless. Been enjoying my new mod for a whole week.

[ + quote]

-------------
Xbox - S-Controllers
X-ecuter2.3b lite [+]
Xecuter bios
Western Digital 7200rpm 120gb HD

s8nsch1ld

Member

24. February 2004 @ 05:10

Link to this message

I think you will need to remove the solder from all 10 -> 12 holes first.

You do this using a soldering iron and some solder braid... don't use a solder pump.

What you do is heat your soldering iron up, add some solder to it, put that down over a hole with the existing solder in it, these will mix and become liquid for 3 secs, then you quickly put some solder braid down over the liquid solder and push down on it with your soldering iron.

You will see the braid fill with solder and the hold you just did should be empty.

It is important that you DO add solder to each one, fluxed solder at that!!!

[ + quote]

S8nsCh1ld!!!
XBox Chipped with a X-Ecuter 2.3b Pro running EvoX on a 120gb HD
Wii Chipped with a CycloWiz V2
PS3
Xbox 360

This message has been edited since posting. Last time this message was edited on 24. February 2004 @ 05:13

iggi

Junior Member

24. February 2004 @ 06:54

Link to this message

you definately dont have to remove anything from a ver 1.0 box. If anything this makes it easier to align the chip. I have installed a few on v1.0 and never had probs.

Iggi

[ + quote]

zeroskull

Newbie

24. February 2004 @ 07:59

Link to this message

thanx guys

[ + quote]

You sold my dead bird to a blind kid?
he, he didn't even have a head.
Harry...Don't worry... I took Care of it = )

afterdawn.com > forums > archived forums > xbox - general discussion > installing xecuter 2.3 lite+


		User name	Password

		Not registered yet? Register here. Lost your password? Click here.