overload on home theatre Receiver


		User name	Password

		Not registered yet? Register here. Lost your password? Click here.

Advertise at AfterDawn.com

Link to us!

Private messages

Compose a private message

List of all updated threads

Threads without replies

Search messages

Saturday 30.8.2025 / 08:55

Search AfterDawn Forums:

afterdawn.com > forums > digital video > video - everything else > overload on home theatre receiver

Browse by topic

Forums

Start a new thread

overload on home theatre Receiver

Jump to:

Posted

Message

roryoss

Junior Member

14. March 2004 @ 06:19

Link to this message

my jvc rx-6018v 500watt systems receiver overloads at a volume level that is so low <35> you can barely hear it, awhile back it would check out at about <65>but i could back it down and it was ok! but this level now is a whisper!! any ideas

[ + quote]

drchips

Senior Member

14. March 2004 @ 07:06

Link to this message

Hiya roryoss,

Welcome to the forums ;)

I noticed you posted the SAME question in the Home Theater PC area, when properly it should have been posted in the Receivers and Amplifiers section!!

But now to the IMPORTANT bit...
As a Newbie you would have seen a splash screen urging you to read the rules BEFORE posting.

The rules Do advise against cross-posting the questions across multiple threads.

Your thread in Receivers and Amplifiers is here:
http://forums.afterdawn.com/thread_view.cfm/76137

Can everyone please follow the link.

Cheers.

[ + quote]

Life is just more of the same:

roryoss

Junior Member

14. March 2004 @ 13:53

Link to this message

well yes i tried bur my search for overload sent me to a place and when i responded i was out of my intended area!!!!!!!!!!!!!!!!!hows that???

[ + quote]

drchips

Senior Member

14. March 2004 @ 14:05

Link to this message

OK,

Obvious questions first:

What has changed, connection wise/input wise, since the last time it worked correctly (bet you did some plugging or swapping around!)??

Have Fun...

[ + quote]

Life is just more of the same:

roryoss

Junior Member

14. March 2004 @ 18:14

Link to this message

nothing really its like its overheating !but it does it right away not like it heats up!!!! i only use this system when watching dvds !i use another for music and tv viewing!!!

[ + quote]

drchips

Senior Member

15. March 2004 @ 03:29

Link to this message

Hiya,

IF you have changed nothing
AND the signal input has not been changed
THEN the unit is probably in need of repair.

You may be looking at a repair bill.

A tip: Local Colleges and University Electronics Departments may be a good place to try and get a cheap repair...

Good Luck...

[ + quote]

Life is just more of the same:

roryoss

Junior Member

15. March 2004 @ 17:26

Link to this message

thanks for the help and advice ,checked fuse it had a bulge in it 6.3 amps 125v, local radio shack only had 5amp 125v,so i used it and could crank the vol up to about <60> before overload !!! so looks like until i find the right fuse keep it at the speed limit<55> should be ok!!! they did have 6.3 250v fuses but said v should not be changed but the amp could vary!!any confirmation on this?????? again thanx!!

[ + quote]

sink

Newbie

16. March 2004 @ 11:47

Link to this message

I had this same problem, and figured out there was a short in one of the speakers. switched out that speaker and can now crank it.

[ + quote]