Originally posted by |CL|:

---

You still have to erase the drive to put the new firmware on it....

Anyway, I'll just give you a generic run down as it is all in the JF tut.

Do the half open tray bit, start JF, click the DVDKey32 Tab (make sure your lite-on is showing up in drive properties), click "Dummy from iXtreme", click yes when JF asks if you want to auto load 1.51, make sure everything looks right between source and target, save if you'd like, click MTK Flash 32, click "Lite On erase", click yes, click yes again, power drive off and back on quickly, hopefully it returns as Status 0x72, click write, wait for it to do it's thing (erase, write, verify), if all is well click "Outro / ATA reset", done.

There it is in a nut shell. Refer back to the JF tutorial for a better description of the steps. :)

---

Quote:

---

make sure everything looks right between source and target, save if you'd like, click MTK Flash 32, click "Lite On erase", click yes, click yes again, power drive off and back on quickly, hopefully it returns

---

Originally posted by hellofice:

---

Originally posted by |CL|:

---

You still have to erase the drive to put the new firmware on it....

Anyway, I'll just give you a generic run down as it is all in the JF tut.

Do the half open tray bit, start JF, click the DVDKey32 Tab (make sure your lite-on is showing up in drive properties), click "Dummy from iXtreme", click yes when JF asks if you want to auto load 1.51, make sure everything looks right between source and target, save if you'd like, click MTK Flash 32, click "Lite On erase", click yes, click yes again, power drive off and back on quickly, hopefully it returns as Status 0x72, click write, wait for it to do it's thing (erase, write, verify), if all is well click "Outro / ATA reset", done.

There it is in a nut shell. Refer back to the JF tutorial for a better description of the steps. :)

---

Just asking...
All you need is ixtreme 1.51 in jungleflasher/firmware folder, SATA cable and xbox power correct ? (or do you need CK3 and other stuff like jungleflasher tutorial says ? )
And what if it can't detect driver properties in jungleflasher ?

and what you mean by:

Quote:

---

make sure everything looks right between source and target, save if you'd like, click MTK Flash 32, click "Lite On erase", click yes, click yes again, power drive off and back on quickly, hopefully it returns

---

Cheers :D

---

Originally posted by |CL|:

---

Refer back to the JF tutorial for a better description of the steps. :)

---

Originally posted by leerage:

---

What type of SATA chipset?

---

Originally posted by hellofice:

---

Any idea what should i do ?

---

Originally posted by hellofice:

---

Any other options ?

---

Originally posted by hellofice:

---

Can some one post a picture of via 6421 chip set ???
Because i was at the store and they had no idea what was via 6421 chip set...

---