Ok, so I had a 1.51 iextreme Lite-On that effed up on me. So I'm replacing the Lite On w/ a Benq and am simply gonna flash the drive w/ the 1.51 firmware I already have.
My question is where/how do I "Browse" for the 1.51 FW on my PC and once I do that, do I simply click "Write"? Do I have to click "Spoof Source to Target" or anything like that?
Originally posted by stevedogg: Ok, so I had a 1.51 iextreme Lite-On that effed up on me. So I'm replacing the Lite On w/ a Benq and am simply gonna flash the drive w/ the 1.51 firmware I already have.
My question is where/how do I "Browse" for the 1.51 FW on my PC and once I do that, do I simply click "Write"? Do I have to click "Spoof Source to Target" or anything like that?
Load you dummy bin in source.
Load ix1.51 for BENQ in the target.
Click spoof.
Save CFW.
Get BenQ in vendor mode (0x73) and write.
I figured it was spoof source to target... saved it
when I click write, I get: "firmware in target buffer is not benq, write aborted"
any ideas?
-------------
oh jeez, such an idiot, i chose the liteon 1.51 FW, didnt realize theres a difference. Just dloaded the benq 1.51, will attempt again and update the discussion :D
