I've been interested in adding a window to an extra OEM case for a few weeks now. Has anyone ever used this tool produced by Talismoon to mod their console?
If so, what were the results? I know some may prefer using a Dremel or similar brand rotary cutting tool but are there any advantages to using this Talismoon one?
They claim:
- Specifically designed for the plastic of the xbox 360 - No power needed, use it under any conditions
- Hand tool reduces chance of mistakes common to power tools
- Easier clean up: Does not create dust or plastic powder
- Greatly reduced risk of flying chips of plastic
Looking at it, I can't figure out how you would use it ... doesn't look very user friendly.
yea just go with the dremel. when i did both of mine, thats what i used for the most part. for the straight edges on one of them, i used a cement board knife as it was easier to drag in straight lines than keeping the dremel going where i wanted it to, but for the curves and all the dremel worked wonders. also i used a little diamond tipped bit that would burn right through the plastic and didnt leave any rough edges.
Come talk with us on efnet at #elitemods !!! or just click ME
ALSO, DO NOT SEND ME MESSAGES ON LIVE REGARDING MODDING CONSOLES, OR HOW I PLAYED A CERTAIN GAME EARLY. I WILL NOT RESPOND. I WILL INSTEAD DELETE YOUR MESSAGE, AND BLOCK ALL COMMUNICATION FROM YOU. JUST SEND ME A PM ON HERE.
