Just a thought, you may want to add that if you miss the powercycle after getting your key, and your xbox is in vendor mode (flashing green light), you need to open the source bin (dummy.bin) and then send erase. I know you guys all touched on this point, but i didnt see anywhere where it says to go and reload your dummy.bin, and i bet that may confuse some folks. I had this happen to me last night, otherwise the tut worked perfectly.
Sorry, for the 83850c. After i got my key, you have to powercycle the dvd drive for 1 second while it writes. Well, my pc hung, so i had to reboot. Of course, my drive was in vendor mode, flashing green and tray open. I restarted and fired up JF, course my drive wasnt recognized, though i wrote down the port it was on. I was stuck for a few minutes until i realized i had to load up the dummy file and the appropriate hacked firmware, then rewrite. Worked perfecty after that. I just thought you might want to add that as i have seen the question posted quite a few times. It may sound like common sense but some people may not know that you have to go load the dummy file and rewrite. Its posted to to just rewrite, not load and rewrite. Might save you some excess posting.
Originally posted by mrhobbes: Sorry, for the 83850c. After i got my key, you have to powercycle the dvd drive for 1 second while it writes. Well, my pc hung, so i had to reboot. Of course, my drive was in vendor mode, flashing green and tray open. I restarted and fired up JF, course my drive wasnt recognized, though i wrote down the port it was on. I was stuck for a few minutes until i realized i had to load up the dummy file and the appropriate hacked firmware, then rewrite. Worked perfecty after that. I just thought you might want to add that as i have seen the question posted quite a few times. It may sound like common sense but some people may not know that you have to go load the dummy file and rewrite. Its posted to to just rewrite, not load and rewrite. Might save you some excess posting.
Thanks again all.
Ahhh, yes I see. If JF is closed, you would have to load the dummy bin back up. The only freeze that I know of is if you are using the VIA card and have the driver installed. In the beginning of the tutorial I put that it needs to be removed to prevent a system freeze.
