|
Power/middle button flashing green light
|
|
|
Melux
Newbie
|
26. November 2009 @ 13:41 |
Link to this message
|
Hi, finally after screwed up original drive (Liteon83850c) i got a new benq...with benq ixtreme-1.61 and it is spoofed as lite-on, with original liteon key..
..now xbox is just flashing green light and drive open/close button is not working.. looks like it freezed @ vendor mode, i can even get it to vendor mode without opening tray half-way. tested with older ixtreme v. 1.6.0 also got a new power cable for drive.. still same thing (tested with another sata cable too)
Maybe it got a wrong key from liteon? it looks fine
67521FE2D1***CENSORED***9EA7D3ED4E6B1
also readed somewhere that even if it is wrong is hould be able to operate it (open/close watch dvd's)
Thanks for you help
|
|
Advertisement
|
|
|
|
|
Melux
Newbie
|
26. November 2009 @ 14:21 |
Link to this message
|
benq drive tested with another xbox, didnt flash firmware, but drive was working, xbox was not flashing green light and open/close button worked ok, think it even plays dvd's without real key. both xbox and drive are new :D just something happed after flash.
|
|
tozadog
Junior Member
|
26. November 2009 @ 17:16 |
Link to this message
|
Hi i know its an obvious one but check the sata and power cable that connect it to your mainboard it could be one of them thats faulty!!!
|
|
Melux
Newbie
|
27. November 2009 @ 08:16 |
Link to this message
|
yes i thought that too, already tested both of them (power+sata) they are ok (got from working xbox),sockets @ motherboard lookd ok too, maybe they are just freezed somehow? ... looks like xbox is stuck with vendor mode (mode-b) even when drive is not in vendor mode, strange.
This message has been edited since posting. Last time this message was edited on 27. November 2009 @ 08:17
|
|
peluynati
Senior Member
|
27. November 2009 @ 09:35 |
Link to this message
|
you should try to put the drive back in vendor mode, if it is a benq hold the tray open and unplug it. once its it vendor mode dont touch any buttons just unplug it and then plug it back up, let the tray close on its own. this may work. if it does not try booting the xbox with the drive plugged in, and not the sata cable see if it boots to the dashboard without that. also make sure your fan is plugged in good and its not wiggled out, if it is unhooked even a little the system will be waiting on that connection.
|
|
vince15NJ
Newbie
|
27. November 2009 @ 10:36 |
Link to this message
|
|
i'm having the same problem
|
|
Melux
Newbie
|
27. November 2009 @ 12:06 |
Link to this message
|
peluynati:
Yes it does boot to dashboard without sata cable. playaed around before with that vendore mode, thing is it is not even tryng to suck drive back in and on/off button is not working, it's like always ready to go vendor mode (drive tested with another xbox, everything was ok)
|
|
Advertisement
|
|
|
|
peluynati
Senior Member
|
27. November 2009 @ 12:22 |
Link to this message
|
|
the reason i asked that was i have a box that is doing the same thing. i have tried everything and came to the conclusion that it needs to be reflowed having a short somewhere that region of the board. your liteon drive was probally ok, its another problem.
|
