when I took the drive out of it case it open when reconneted but when I put the in and put but in it shell and put the screws in it won't open does anyone know how to fix?
Originally posted by achene: when I took the drive out of it case it open when reconneted but when I put the in and put but in it shell and put the screws in it won't open does anyone know how to fix?
Did you make sure you plugged the power back in?
Have you tried ejecting with both the button & the dash?
Did you by any chance erase the firmware off your drive?
no it still plays game just it keep happen one day it works and then I have to take it apart again for it to work. Yes I,ve both way but it will screw up once I put it in the Xbox
As the drive is trying to eject, tap it on top with your finger several times with a small to medium amount of force and it should open. Once it is opened, use a knife, toothpick, or whatever to clean around the edges of the drive where it might be sticking.
$38 on new discs -- Check
$15 on burn after burn that showed as a DVD -- Check
$11 on new laser -- Check
$28 on new multimeter -- Check
___________________________________
Knowledge from Leerage? -- Priceless
Take apart the 360 and take out the BenQ drive. Take out the 4 screws that hold the 2 plates on the BenQ. Flip it over and you should see this:
Push that bar in and the tray should pop out a bit. Pull the tray half way out and flip the drive back over. By the gears you should see a small rubber belt. Take it off. Warm up some hot water in the microwave and let it sit in there for a bit. Take the belt out and clean it off. Put the belt back on and re-assemble. That should resolve the issue with the tray sticking.
Originally posted by leerage: Take apart the 360 and take out the BenQ drive. Take out the 4 screws that hold the 2 plates on the BenQ. Flip it over and you should see this:
Push that bar in and the tray should pop out a bit. Pull the tray half way out and flip the drive back over. By the gears you should see a small rubber belt. Take it off. Warm up some hot water in the microwave and let it sit in there for a bit. Take the belt out and clean it off. Put the belt back on and re-assemble. That should resolve the issue with the tray sticking.
