Hi, i have just tried flashing a Liteon 74850c, i have all the bin files and cfw saved, when i went to liteon erase it gave me all the correct chip properties (i think) I wouldnt mind i did a drive of the same make and model the other day and all went fine. Then i went to write and it said erased and then writing bank 1 and then froze, i deleted the via driver before hand too and enabled in device manager.
Now when i open jf it does not show drive, i know drive is erased but dont know how to sort it, where do i put the dummy.bin file, when i try the liteon erase again it gives me (Drive Returned Status 0xF2) please someone help, Thanks in advance!!
Originally posted by sn0wman1: Hi, i have just tried flashing a Liteon 74850c, i have all the bin files and cfw saved, when i went to liteon erase it gave me all the correct chip properties (i think) I wouldnt mind i did a drive of the same make and model the other day and all went fine. Then i went to write and it said erased, and then writing bank 1 and then froze, i deleted the via driver before hand too and enabled in device manager.
Now when i open jf it does not show drive, i know drive is erased but dont know how to sort it, where do i put the dummy.bin file, when i try the liteon erase again it gives me (Drive Returned Status 0xF2) please someone help, also if i load up dosflash it sometimes shows chip properties but when i try to write it just hangs on erase, Thanks in advance!!
UPDATE:
I may have done something silly, i dont know but i pressed on the outro button, now it wont show chip properties in Dosflash 1.8 and Drive Returned status is now 0x80 or something, please help, thanks
you erased it, so it's not going to. There is no firmware on it. Just resend the erase even though it doesn't show up. Get it in vendor mode and flash it.
Originally posted by Modking30: you erased it, so it's not going to. There is no firmware on it. Just resend the erase even though it doesn't show up. Get it in vendor mode and flash it.
Tried that, finally got it into vendor mode, pressed write and froze again at writing bank 1, could my cfw be wrong as when i extracted the keys, it is supposed to give you 6 keys, well it only gave me one, but i went to save and it gave me all of the bin files plus i made the dummy.bin and cfw?
Thanks for your reply matey but i got it sorted, turns out i had too much running on pc, ie themes,antivirus internet all that sort of stuff, disabled it all, jf did not work but dosflash 1.8 worked first time, i also changed the port on my via card, dont know if that had anything to do with it, but thanks again.
