hi i just got a new mobo, cpu, and video card, i was wondering about how to install the cpu/fan, when i put in the chip and i want to put the fan onto the chip, should i remove the stickers thingy on the fan or what, or can someone please explain to me on how to install those parts, sorry if this is the wrong place to post but im in need, thanx in advance
2.4 ghz, nothing to fancy really, i got these parts as i shown them before, but the downfall was when i got them, i found out that my old ram was a different type than the one i need for my new one, so im trying to find at circuit city or best buy ram that can fit in there, because im flat broke because i just went out on vacation and i know my parents wouldnt buy me anything online like i did, but here are the parts in case u are curious,
sdram, my new mobo supports ram with only space missing in the middle, but my old ram has like 3 spaces missing on the bottom, sorry for not being more specific because i dont know much about ram
2 spaces not 3 for sdram. i have the p4 2.5 celeron d on my board. install the board into the case before installing the cpu & especially the heatsink & fan because when the bracket assembly is clamped down it warps the board. when the heatsink assembly is put in place, make certain it is centered on the cpu, not partially sitting on the board bracket, is hooked on all 4 corners than rotate the 2 whit toggles in opposite directions to each other to clamp down. you may think you are going to break it but won't if everything is properly seated.
you want the pc3200 ddr ram. i think your board can handle 4gig as it has 4 ddr sockets so depends on how deep is your wallet. can get 2-256s or 1 or 2-512meg ddr. if get 1 stick now than try to get another soon so that if 1 goes bad still have the 2nd to run on
