|
!!HEAT!! tsss HoT
|
|
|
pudge
Member
|
27. April 2006 @ 16:38 |
Link to this message
|
ok so i put together my computer and it boots up and shows me the mother board screen brand name and after about 15secs of it being on the computer shuts it self down.
whats the problem?
i have 2 hhds, 1 dvd-rom, 2gig of ram, and a video card with a
intel Dual 830 chip and this mother board
http://canadacomputers.com/index.php?do=ShowProduct&cmd=pd&pid=00...
any ideas???
ps2 ver 1(old school)
swap magic version 2
flip-top
----------------------
xbox version 1.6
|
|
Advertisement
|
|
|
|
Senior Member
|
27. April 2006 @ 17:06 |
Link to this message
|
|
check to make sure you cpu cooling fan is working first
if it is unhook all drives and boot PC see if it stays on then install each drive individualy reboot after each one and see if you can indentify the hardware causing the crash post back the results
|
|
pudge
Member
|
27. April 2006 @ 17:12 |
Link to this message
|
|
ya the fans are in working order, could it be that the cpu fan is off placed a little bit?
i'll try unhooking the drives should i leave 1 in though like the harddrive?
ps2 ver 1(old school)
swap magic version 2
flip-top
----------------------
xbox version 1.6
|
Senior Member
|
27. April 2006 @ 17:27 |
Link to this message
|
|
Make sure the cpu fan is placed squarly on the chip and unhook all drives the mother board should still boot
|
|
pudge
Member
|
27. April 2006 @ 19:19 |
Link to this message
|
|
i did that i locked down the chip fan and i started to install windows then it shut off, so i took off my side fan tunnel and then i was able to install windows becasue for some reason the computer stays alvie longer without that fan.
but now everytime windows loading screen comes up and just before u login it turns off.
the cpu temp is at anywhere between: 61-66 when im looking at the setting and the motherboard is at 38
ps2 ver 1(old school)
swap magic version 2
flip-top
----------------------
xbox version 1.6
|
Senior Member
|
27. April 2006 @ 21:52 |
Link to this message
|
|
If your cpu is rising to 66 deg C in the time it takes to load win either your fan is totaly inadequate or not seated properly
|
|
pudge
Member
|
28. April 2006 @ 08:58 |
Link to this message
|
|
ok so i unhooked the cpu fan and put it back in place i thought i put it in right.
my cpu now runs at 48-55 and mother baord at 36-40
it was running fine for about 20mins then i started to play a game and 10 mins in the computer turned off??GRR
what can i do?
ps2 ver 1(old school)
swap magic version 2
flip-top
----------------------
xbox version 1.6
This message has been edited since posting. Last time this message was edited on 28. April 2006 @ 12:06
|
Senior Member
|
28. April 2006 @ 13:25 |
Link to this message
|
|
There may be a setting in your bios that is ordering a shut down at a certain temp check your manual
|
AfterDawn Addict
|
28. April 2006 @ 13:39 |
Link to this message
|
|
Get a GOOD PCI fan and get your system cool.
I recommend the POWERCOLOR fan as it has 2 fans,
(One of them pivots). Speed control settings and exhaust too.
and is only around 20 Bucks.
There is also a free spogram called Speedfan.
It will monitor your fan speed and system temperature,
And will allow you to turn up the fan's speed if needed.
Cheers!
Possunt Quia Posse Videntur. |
Junior Member
|
28. April 2006 @ 17:50 |
Link to this message
|
|
did you install a new cpu? or is an old one you transfered over? maybe your heat sink compoud is non existant. if you seperated the heatsink from cpu you should always replace the compound. Artic ice seems to be the preferred compound on these boards. honestly any heat transfering compoud will do the trick. Just dont over do it becuase too much can be like too little.
This message has been edited since posting. Last time this message was edited on 28. April 2006 @ 17:50
|
|
pudge
Member
|
28. April 2006 @ 19:26 |
Link to this message
|
|
yes it is a new cpu, but that maybe the answer ( the compound) becasue i did install and unstall it a couple of times to see if it was in right and i saw this like melted gery material and didnt no what it was ( ohh well lol)
because everything runs fine like 44C when doing nothing then rising to 54-60 when doing work then turns off randomly when its in the 56-60 area
ps2 ver 1(old school)
swap magic version 2
flip-top
----------------------
xbox version 1.6
|
Senior Member
|
28. April 2006 @ 20:55 |
Link to this message
|
|
The melted gery material is probably the old heat conductive tape it good for one use only clean it off and install a thin layer of a good quality paste and check your manual and see if it has a over heat shut down setting in your bios it may need to be adjusted to a higher threshold
|
Junior Member
|
28. April 2006 @ 21:26 |
Link to this message
|
|
44c is a lil high for idle.i would replace the compound and check your idle and load temps again
|
|
pudge
Member
|
29. April 2006 @ 08:19 |
Link to this message
|
|
i dont understand why i would have to change the termal compound when
the computer has only been running for 3 days..lol
what do they give u some shitty compound with the cpu?
i got my cpu to 41 idle but once i start doing something that takes some work it hits 48 and starts to make a scrathing sound and about 30secs of scrathing it usually turns off
ps2 ver 1(old school)
swap magic version 2
flip-top
----------------------
xbox version 1.6
This message has been edited since posting. Last time this message was edited on 29. April 2006 @ 08:53
|
Junior Member
|
29. April 2006 @ 17:29 |
Link to this message
|
|
the termal paste used on a new heat sink is a one time deal. so once the seal is broke it stops doing its job. Hopefully we havent burnt the cpu yet.
|
|
pudge
Member
|
30. April 2006 @ 17:03 |
Link to this message
|
|
noo wayy no cpu burnt lol,, cross fingers
ps2 ver 1(old school)
swap magic version 2
flip-top
----------------------
xbox version 1.6
|
|
pudge
Member
|
3. May 2006 @ 15:42 |
Link to this message
|
|
GRRRR
ok so i put on some new thermal paste and i have the same problem!!grr
cpu idle at 36
mtherboard at 30
on work cpu = 46 to 50
motherboard = 32 to 36
still get the srcathing noise for about 30secs then shuts off.. i dont get it i thought those heat levels would be normal?
and whats with the scrathing errrr
ps2 ver 1(old school)
swap magic version 2
flip-top
----------------------
xbox version 1.6
|
Member
2 product reviews
|
4. May 2006 @ 07:07 |
Link to this message
|
Quote:
ok so i put together my computer and it boots up
So this is a custom build PC??
If so what case are you stacking it in, could be your case is not adequette enough.
If this is custom build PC can you tell us the specs of the PC and what case you have for it please.
This message has been edited since posting. Last time this message was edited on 4. May 2006 @ 07:08
|
|
pudge
Member
|
4. May 2006 @ 07:42 |
Link to this message
|
ps2 ver 1(old school)
swap magic version 2
flip-top
----------------------
xbox version 1.6
|
Member
|
4. May 2006 @ 07:55 |
Link to this message
|
|
Are you 100% sure that you have an adequate Power Supply in there? It seems that as you reduced the number of devices, the problems got less and less. That could be a PSU that simply cannot cope.
|
|
pudge
Member
|
6. May 2006 @ 11:38 |
Link to this message
|
|
im sure its not the PSU
well here is the temps yet agian lol:
temp1: 44
temp2: 35 <<<this is with program fanspeed
temp3: 32
HD0: 29
temp1: 40
when i do work temp1 and temp3 skyrocket up to 55 and jump up and down from 55 to 66 and like 55 to 74 and so on until the comp makes high pitch screeching noise and turns off
ps2 ver 1(old school)
swap magic version 2
flip-top
----------------------
xbox version 1.6
|
|
pudge
Member
|
8. May 2006 @ 19:39 |
Link to this message
|
|
i have 1 last idea... i never set the mother board and the cpu to match
speeds i heard someone talking about this before but i have no idea?
can anyone help?
ps2 ver 1(old school)
swap magic version 2
flip-top
----------------------
xbox version 1.6
|
|
Advertisement
|
|
|
|
pudge
Member
|
10. May 2006 @ 16:24 |
Link to this message
|
|
just toppin da chartss**
ps2 ver 1(old school)
swap magic version 2
flip-top
----------------------
xbox version 1.6
|
