|
I have an asrock k8upgrade vm800 socket 754 mobo with an amd athlon 64 3000+ @2.2g1hz & have just ran sisoftware's sandra 2007 pro.
According to sandra, my motherboard bios needs updated.
I found the bios i need on the asrock site, but it doesnt tell me how to backup the bios or reflash it if it all goes pear shaped..
Also sandra also says smbios/dmi information may be inaccurate..
It also says FSB exceeds chipset rated speed & says large memory modules should be made of registered/buffered memory,
& they should be EEc/Parity..
I'm sure my memory is registered as its 2x1gb corsair twinx xms matching pair ddr400 pc3200 @ 3.3.3.8 latency..
Also sansra says my cpu can go from 1.6 - 2.4GHz & the cpu voltage is 1.52, my FSB is at 221 with a multiplier of 10..
It also says the temp of my mainboard & cpu is 38.0c/100.4f & 37.0c/98.6f & was wondering if this is high or ok..
I have a coolermaster hyper 6 100% copper heatsink/fan,
an antec case exhaust, a speeze hard drive cooler with 2 fans
& various other fans..
Does amyone have any advice for me as i have tested my cpu with
cpu-z for 24 hours on full load & have had no problems?
My pc is never off & i hardly ever have problems with it.
Since sandra says it can go to 2.4GHz, i was going to try this, but my multiplier doesnt let me go past 10.
I was going to reduce the FSB & increase the mulitiplier,
but after slecting the x11 multiplier & rebooting,
it just resets itself or fails to boot!!
any help is appreciated, thanks
P.S my uncle is having the same problem regarding the bios.
He has an intel p4 on a dfi lanparty pro875 rev a..
Thanks
<*_*>
This message has been edited since posting. Last time this message was edited on 10. December 2006 @ 05:53
|
