I unplugged my video card to install a wireless card, then reinstalled the video card, and now my monitor will not come out of analog power saving mode. Any ideas about what I may have done wrong? Thanks!
Well, the video card is perfectly seated in the AGP slot. I removed the wireless card, but the monitor still will not come out of power saving mode. hmmmmm
make sure the monitor is plugged in at all parts expecially where it goes into the agp card, i have a problem w/ my case b/c the vga out is so close to the side of the case i just have to force it on and i cant tighten the screws, try the other output if theres more then 1
I can safetly say once i pulled out my AGP graphics card and repluged it i kept getting No Signal Input. GOing to Power Save Mode ...
To solve return it if it is covered under warranty, it solved my problem
ex. ATI has great service/repair
I am confident you fried your card, if u are sure it is seated properly and no display appears and ur onboard intel/misc one works with ur agp one removed
Thanks for the advice, but actually, I just happened to try turning on the pc again, and it powered up just fine. *shrug*
If it acts up again, I'll definitely contact ATI.
aww lol i wish my same problem u had, was solved so easily like urs, ati told me it was a fried card, and once i got my new 1 it was fixed :P but it happened AGAIN yesterday and i sent back today :( i bet my power outage had somethign to do with it
