HI,GUYS HELP ME OUT HERE,I DISABLED WINDOWS firewall,SO THAT SHRINK WOULD ENCODE FASTER,I RIPPED THE MOVIE POSEIDON,WITH DVDFAB DECRYPTER,AFTER SHRINK ANALYSED THE MOVIE ITS TAREGET WAS 4,464 MB,I ENABLED THE DEEP ANALYSIS OPTION,THE TOTAL PROCESSING TIME WAS, 59 MINUTES,THIS WAS A HUGE DIFFERENCE COMPARED TO THE 2HOURS AND THE 3 HOURS SHRINK NORMALLY TAKES TO ENCODE A MOVIE,HOWEVER THE PROBLEM IS,WHEN I WAS READY TO BURN THE MOVIE THE TARGET WAS ACTUALLY,4,655MB,AND IT COULD NOT HOLD ON A REGULAR BLANK,SO COULD SOMEBODY PLEASE TELL ME WHAT HAPPENED,AND WHAT I CAN DO TO CORRRECT IT.
Please turn off your caps, it is considered shouting.
Reduce your target size in DVD Shrink to 4360 and try again. Unless you've just got an older underpowered PC it shouldn't take anywhere near 3 hours to encode a movie...I've got an older 2.4 machine with a gig of ram that I can backup from start (ripping) to finish (burning) in about 45 minutes doing only the main movie. You might check your DMA setting in Device Manager.
Unless you disconnected your machine from the internet, what would you do something like that? That's a good way to get owned, especially if you haven't patched lately.
-Do you believe you own your computer and shouldn't be told what you can run and do? Then say *NO* to Microsoft Vista!
-Since half the questions here involve media problems, here ya go: Only use Verbatim or Taiyo-Yuden discs (get your TYs from Rima.com, not Supermediastore or meritline). Forget the rest, no matter what "brand" they sell under. Always burn at 4x speed regardless of the speed rating of this discs or your drive. If you have burn problems with these then you have to update your drive's firmware. For double-layer discs, only use Verbatim DVD+R DL and burn them at 2.4x speed.
