|
Samsung TS-H943 tray won't open
|
|
|
maxmc2
Newbie
|
27. November 2009 @ 14:17 |
Link to this message
|
Hi Guys
Got my mates Xbox to flash and have come up against a slight problem.
Was using jungleflasher as with others did the half tray open etc and power down, then when i went to read the drive it just crashed, now when i try to eject the tray it doesnt open and all i get is a flashing green light and one red light.
I have deleted all the drivers for the VIA chipset which worked with others but cant see why this has crashed, seems to have buggered the drive up and i cant get into it?
Any ideas on how to sort this problem?
Thanks in advance
|
|
Advertisement
|
|
|
|
|
gameover9
Suspended permanently
|
27. November 2009 @ 15:05 |
Link to this message
|
Usually a bad belt on the drive. I'd trash it and get a benQ
|
|
maxmc2
Newbie
|
27. November 2009 @ 16:33 |
Link to this message
|
My question now is I have the backup firmware from the drive how do i restore it to the drive whilst it's in this state?
|
|
peluynati
Senior Member
|
27. November 2009 @ 16:52 |
Link to this message
|
|
flashing the drive should have nothing to do with its physical state. i have read drives that were nothing more than the board themselfs left.hahaha. sammy is the hardest drive to mess with, but if you get windows to recognize it jungleflasher will do its job.
|
|
maxmc2
Newbie
|
27. November 2009 @ 16:55 |
Link to this message
|
|
Yeh but how can I get it to see the drive if the tray won't open help!
|
|
peluynati
Senior Member
|
27. November 2009 @ 16:58 |
Link to this message
|
i cannot guarntee that this will work, but it did for me once. i searched for new hardware, instead of installing the xbox driver, i chose from a list and picked samsung dvd drive and it picked it up, even showed up in windows with a drive letter. you may give that a try.
|
|
gameover9
Suspended permanently
|
27. November 2009 @ 17:01 |
Link to this message
|
Originally posted by maxmc2:
Yeh but how can I get it to see the drive if the tray won't open help!
Didn't I already tell you? If it sees the drive and doesn't eject, then the belt is bad. Try cleaning it. It will come back. Get a BenQ and spoof to that or you'll continue to have the problem.
|
|
maxmc2
Newbie
|
27. November 2009 @ 17:23 |
Link to this message
|
|
Yeh but it doesn't see the drive that's the problem
|
|
gameover9
Suspended permanently
|
27. November 2009 @ 17:46 |
Link to this message
|
Originally posted by maxmc2:
Yeh but it doesn't see the drive that's the problem
Try dosflash then, I thought JF was seeing it. Use dosflash to flash back to OFW and JF to flash to 1.6.1
|
|
Advertisement
|
|
|
|
maxmc2
Newbie
|
27. November 2009 @ 18:22 |
Link to this message
|
|
Can't seem to get it to see the drive in dosflash either just locks up and windows doesn't see it any ideas anyone? :(
|
