Originally posted by pjmorie:

---

Managed to do that on my own! Could get the hang of these techninal things!!

---

Originally posted by Elvis64:

---

Need some help please.
I have a Black Eurovox MaxV which was dropping channels, giving a no signal error. I also have a replay lite which works fine off the same input. So I upgraded the box again,I had already done it in April, with the UFL_MaxV_Kuro3_18_04_08 file. I then selected factory default & did a rescan but only 4 channels have come up but no stations. My settings are as follows

Model - DVB-XC BOXV DTA, S/W VER 1.0 STC4 APR 18 2008
H/W VER 2.0T K5, BOOTSTRAP V001, S/W BUILD KURO

Any ideas would be appreciated

---

Originally posted by Elvis64:

---

I see in Eamo's library there is a firmware update dated 28/04/08.
Should I update my Eurovox MaxV with this I wonder?

---

Originally posted by sc0user:

---

You could see the channels because you had found the transponders, but hadnt updated the channels also.

---

Originally posted by sc0user:

---

I presume you are in Ireland? If so, its a problem specific to the Irish EPG stream, you need to follow these instructions:

1. Pull plug on the back of the EV for a few seconds then plug back in again..
2. When EV powers up, immediately press menu, configuration and time settings.
3. Set correct time using GMT settings.
4. Then turn GMT OFF.
5. Press blue button to save and exit.


It may take more than one attempt so just be patient, it does work. One thing to note though when you have the EPG correct, is to just put it in standby at night, if you unplug it you will have to go through the whole process again.

---